iStream DockFree Bluetooth Audio Receiver

Product Application

The diagram illustrates connecting the iStream DockFree Bluetooth Audio Receiver to a speaker. It shows an 'AUX IN' port on the receiver and a 3.5mm audio cable connecting it to the speaker. The text indicates that the iStream can transmit music from a digital device up to 33 feet.

Connect the iStream to any speaker or dock with a 3.5mm audio jack.

Operation

Charging the Battery

The battery is not fully charged and it is highly recommended that you charge the AIS01F before you begin using it. Using the AIS01F "out of the box" will not harm the device, but you will experience reduced battery life as the unit will not be fully charged.

Connect the USB end of the cable provided to your PC and the charger plug to the charging jack of AIS01F. Please charge the battery for a minimum of 3 hours. The Red LED will be on while charging. When charging is complete, the red LED will turn off.

The diagram illustrates charging the iStream with an included USB cable. It shows the receiver connected via a USB cable to a power source. The 'Power button' is also visible on the device.

Device Functions and Indicators

Pairing with Devices

Note: The pairing mode will last 2 minutes. AIS01F will switch to the standby mode automatically if no devices can be connected within 2 minutes.

Pairing with a transmitter such as iPhone, smart phone, and tablet:

Please make sure the device supports A2DP profile. The pairing procedure will vary depending on the actual device. Please refer to the user guide of your device for detailed instructions. The general pairing procedures are as follows:

1. Make sure AIS01F is turned Off.
2. Activate AIS01F pairing mode by pressing and holding the power button for 6-7 seconds.
3. Activate your device's Bluetooth function and set your device to search for Bluetooth devices. Select AIS01F when it is found.
4. For transmitters with Bluetooth version 2.1, you will not need to input a code. If you are prompted for a PIN, please enter "0000".
5. If prompted by your device to connect, please select "Yes".
6. After connecting successfully, the blue LED will flash twice every 5 seconds.

Note: Please make sure the audio output is set to Bluetooth / AIS01F for audio streaming from the device.

Tech Support & Warranty Information

If you need further assistance, please contact the Aluratek support department for troubleshooting prior to returning this device.

• E-mail: support@aluratek.com
• Web: www.aluratek.com/support
• Local (Tustin, CA): 714-586-8730
• Toll free: 1-866-580-1978

Aluratek warrants this product against defects in material or workmanship for 1 Year from the date of purchase.

For more information, please visit: http://aluratek.com/warranty-return-policy

You can register your product online at: http://aluratek.com/product-registration

Radio and TV Interference Statement

WARNING!!! This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by whatever measures may be required to correct the interference.