WIRELESS BACKUP CAMERA

Step 1: Charge the Camera

Fully charge the camera. Fold back the camera's power port plug and insert the included charging cable. Most AC wall adapters are compatible with the USB charging cable.

NOTE: Fully charge and test the camera before installation.

Step 2: Power On Monitor and Camera

Plug the 12V/24V power adapter into the monitor to turn it on. Turn on the camera by pressing the silver power button located beneath the lens for 1 second. The blue LED status indicator will flash twice, and an image should appear on the monitor.

Step 3: Remove License Plate

Unscrew your vehicle's license plate.

Step 4: Mount the Camera

Align the camera with the license plate and secure it to the vehicle. Refer to the full manual for additional mounting guidance.

Step 5: Mount the Monitor

Place the Windshield Mount on the windshield or use the Dash Mount. Lower the lever to secure the mount. Attach the Dash Monitor onto the chosen mount and adjust it to your desired viewing position.

Step 6: Power the Monitor

Mount and power the monitor. Use the provided 12V/24V adapter for power. Remove any protective overlay and adjust the monitor's angle as needed.

Step 7: Activate the Monitor

After connecting the monitor to power, wake up the monitor and camera by waving your hand in front of the monitor or tapping once on the screen.