ResMed

Quattro™ Air for Her Full Face Mask

This guide provides step-by-step instructions for fitting your ResMed Quattro Air for Her full face mask.

1. Step 1: Prepare the Mask

   Remove the elbow from the mask by pressing the side buttons and pulling the elbow away. Pull the headgear over your head with both lower headgear straps released.

2. Step 2: Adjust Upper Straps

   Adjust both the straps of the upper headgear evenly until the mask is stable.

3. Step 3: Secure Lower Straps

   Bring the lower straps below your ears and loop the headgear into the lower hooks on the frame.

4. Step 4: Adjust Lower Straps

   Adjust the lower headgear straps evenly until the mask is stable. The fitting should be firm but not uncomfortable. Do not over-tighten.

5. Step 5: Connect Air Tubing

   Connect the air tubing from your device to the elbow. Attach the elbow to the mask by pressing the side buttons and pushing the elbow into the mask. Turn on your device so it blows air.

6. Step 6: Final Seal Check

   Undo the fastening tabs on the upper headgear straps. Reposition both of the straps evenly, only enough until a seal is achieved, then reattach the fastening tabs. Your mask is now ready to use.

The Quattro Air for Her is designed to accommodate your hairstyle above or underneath the headgear.

Note: For additional information, refer to the Quattro Air for Her Full Face Mask User Guide.