Huawei Watch Jewel Strap Replacement
Use this guide to replace the straps on your Huawei Watch Jewel
Written By: Alejandro Hernandez
Introduction
This guide will demonstrate how to replace your watch's straps. Some of the tools used in this guide are relatively sharp, so make sure to use them with care.
Tools and Parts
Tools:
- 64 Bit Driver Kit (1)
- 150 mm Flex Extension
Parts:
- Huawei Watch Band Strap (1)
Step 1: Strap
Begin by laying the watch on a flat, smooth surface.
? This will prevent the watch screen from suffering damage.
Obtain a Flex Extension with a Size 1.0 mm flat-head. In the case of not having said tool, for this model of watch one can use the hands to replace the strap.
Image Description:
The first image shows the Huawei Watch Jewel laid flat on a surface, with a white strap attached. Next to it is a screwdriver tool with a flexible extension. The second image shows a closer view of the watch back, with the screwdriver tool positioned near a spring mechanism.
Step 2
Locate the two springs on the back of your watch.
? The watch comes with two of these springs on each side of the back-face. These are used to release the straps from the body of the watch.
Image Description:
Two images display the back of the Huawei Watch Jewel. The first image highlights two spring-loaded pins on the underside of the watch lugs, indicated by red squares. The second image shows a finger pressing one of these springs.
Step 3
Use the Flex Extension to push the spring to the right. This will release the strap from the watch head.
Image Description:
Three sequential images illustrate the process of releasing the watch strap. The first shows a screwdriver tool with a flat-head tip being inserted into the spring mechanism on the watch back. The second shows the tool pushing the spring to the right. The third image shows the strap beginning to detach from the watch body.
Step 4
Carefully pull the strap away from the watch.
Image Description:
A hand is shown carefully pulling the detached watch strap away from the Huawei Watch Jewel.
Step 5
Repeat step 3, this time using the other strap.
Image Description:
The first image shows the process of repeating step 3 on the opposite side of the watch, using the screwdriver tool to push the spring for the second strap. The second image shows the other strap being carefully pulled away from the watch.
Reassembly
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-11-30 01:18:29 AM.
