YAKIMA EXO SwingBase™

Installation

1. Insert the Tongue into the Vehicle's Hitch

   Insert the tongue into your vehicle's hitch and align the holes.

   Note: If there is interference, you can install the hitch bolt from the opposite side if you reverse the nut plate. Unscrew the retaining screw, reverse the nutplate, and reinstall the retaining screw. Tighten to 2 Nm.

   Install the hitch lock and use a key to lock it.

   Note: If you choose not to use the hitch lock, install the bridge pin in its place.

2. Install the Hitch Bolt

   Use a 24 mm wrench to install the hitch bolt and washer as shown. Fully tighten the bolt to 100 Nm.

3. Attach the Swing Base to the Tongue

   Align the holes of the swing base with those of the tongue and use the wrenches to install the 2 bolts and 2 nuts as shown. Tighten completely to 100 Nm.

Operation

1. Extend the Arms

   A. To extend the arms, first extend the driver-side arm by pulling the pin and swinging it outward until the arm locks into place.

   B. Then pull the pin for the passenger-side arm and extend it until it locks into place.

   CAUTION: Keep your fingers away from ALL moving parts!

2. Swing Open the EXO SwingBase™

   Loosen the large knob, then pull the pin and swing the unit open until the pin engages and locks the gate into the open position.

   Note: EXO SwingBase has a 1º upward tilt to prevent sagging while under load.

3. Close the EXO SwingBase™

   A. Pull the pin at the pivot point.

   B. Swing the gate by the handle toward the vehicle.

   C. Use the handle to guide the EXO SwingBase up the ramp, and into the closed position.

   D. Tighten the large knob to 25 Nm.

   IMPORTANT: Ensure that the pin is engaged, and fully tighten the large knob before operating your vehicle.

4. Collapse the Arms

   To close the arms first close the passenger-side arm by pulling the knob and swinging it closed until it locks into place. Then pull the knob for the driver-side arm and swing it closed until it locks into place.

Removal

1. Remove the Assembled EXO SwingBase™

   With help from a friend, pull up on the right side so that the EXO SwingBase is level. Use a 24 mm wrench to loosen the bolt, then remove the bolt the rest of the way by hand being careful to not damage the threads of the bolt.

Reinstallation

1. Reinstall the Fully Assembled EXO SwingBase™

   With help from a friend, pull up on the right side so that the EXO SwingBase is level. Install the washer and hitch bolt by hand being careful to not damage the threads of the bolt. Then use a 24 mm wrench to tighten the bolt completely to 100 Nm.

Care and Maintenance

• Attachment hardware can loosen over time. Check and tighten if necessary, before each use.
• Be sure all hardware is secured according to instructions. Failure to perform safety checks before driving away can result in property damage, personal injury, or death.

YAKIMA products should be cared for and maintained.

• To clean, use only mild detergents. Harsh detergents could damage this product.
• Remove this product before entering an automatic car wash.
• Hardware such as locks should be lubricated with graphite or other dry-lubricants.

IMPORTANT! Be sure to read all the warnings and warranty information contained in the insert accompanying these instructions!

Recommended Accessories

Visit Yakima.com or your preferred dealer to purchase or research these accessories.