Contents
01 IMPORTANT SAFETY INSTRUCTIONS
General Safety
The appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Use the appliance as described in the user manual only. Any other use not recommended in the user manual may cause fire, electrical shock, or personal injury. Ensure that the fan is switched off from the supply mains before removing the guard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Operation Safety
- Place the appliance on a flat, dry surface before use.
- Do not immerse in water and any other liquids.
- Do not use the appliance until the base is installed.
- Do not insert your fingers, pencil, and any other objects into the grilles while in operation.
- Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.
Electricity Safety
- Make sure that the voltage of your electricity supply is the same as that indicated on the appliance.
- Always unplug before cleaning or leaving the appliance unused for a long period of time. Keep your hands dry when plugging/unplugging.
- Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliance. Arrange cord away from traffic area and where it will not be tripped over.
- WARNING: To reduce the risk of fire or electric shock, do not use this Fan with any solid-state speed control device.
- WARNING - If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
FOR HOUSEHOLD USE ONLY
READ AND SAVE THESE INSTRUCTIONS
Gentle Reminder:
- Check the appliance regularly and refer to TROUBLESHOOTING or contact customer support if it shows any of the following signs:
- Power cord or plug is damaged.
- Loud noise, unusual smell or excessive heat.
Specifications
Model No. | Input | Rated Power | Battery Type |
---|---|---|---|
DR-HTF018S | AC 220-240V 50Hz | 35W | CR2025 3V |
Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household waste throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection system or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
02 ASSEMBLING YOUR TOWER FAN
Assembly Instructions
When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.
- Run the cord through the center hole of the two base halves.
- Intersect the two base halves diagonally. Match the arched cutout with the arched support on the base. Then, hook them together.
- Press down on the edge until you hear a click to securely snap the two base halves together.
- Attach the base to the fan bottom.
- Make sure the arrows on both the base and fan bottom are aligned.
- Turn the base clockwise until it clicks into place.
- Thread the cord through all REAR cord keepers, then set the fan upright.
CAUTION
- Do not operate the tower fan if the base has not been installed.
- Make sure to thread the cord through all rear cord keepers.
03 CONNECTING TO YOUR TOWER FAN
Before connecting the appliance to your mobile device, please scan the QR code on the left or go to the app store and search “DREO”, then select and download the app.
Look for "Cruiser TF518S" when connecting your new tower fan.
You can use the DREO app to connect your smart tower fan to Amazon Alexa or Google Home. Please follow the in-app instructions to set up your voice assistant.
NOTE: You must create a DREO account to access voice assistants.
- Launch DREO and sign in or create an account by following in-app instructions.
- Enable Bluetooth on your mobile device and plug in your tower fan.
- Hold the Oscillation button ⚙️ for 5 seconds to start WiFi connection settings. (Tip: The WiFi icon will keep flashing when pairing.)
- Tap + Add Device and select Cruiser TF518S.
- Follow in-app instructions to complete WiFi connection.
- You're now ready to control the appliance on your app. (Tip: To restart connection settings, hold the Oscillation button ⚙️ again for 5 seconds.)
- Long press ➕ and ➖ for 10 seconds to unpair WiFi and restore factory settings.
04 KNOWING YOUR TOWER FAN
Control Panel
- Power Button: Turn power on/off
- Mode Button: Switch between Normal/Natural/Sleep/Auto Mode. Long press to mute/unmute.
- Increase Button: 1-9 speed levels
- Decrease Button: 1-9 speed levels
- Timer Button: Select to set a timer (0-12h)
- Oscillation Button: Adjust airflow direction. Long press 5s to start network settings and device pairing.
LED Display
The LED display shows the current operating mode, fan speed, timer settings, and WiFi status.
05 USING YOUR TOWER FAN
Working Modes
- Normal Mode: Fan runs at the fixed speed.
- Natural Mode: Fan speed goes up and down intermittently to replicate the natural breeze.
- Auto Mode: Fan automatically increases speed when room temp is higher and decreases speed when temp is lower.
- Sleep Mode (Mute Auto On): Balances comfort and noise by automatically decreasing fan speed as you fall asleep. If the fan speed is higher than 3, it will decrease two times, one speed every 30 minutes, then it will remain constant. If the fan speed is 3 or below, it will remain constant.
Additional Features
- Mute: Long press ? or press ? on the remote control to turn on/off the button sounds.
- Firmware Update: Check the firmware version on the DREO app and update regularly for the fan to work more efficiently. Display will show “UP” during the update process. Do not operate until the update is completed.
Timer
When the fan is ON/OFF, touch the timer button ⏱️ repeatedly to set a timer (1-12 h). When the timer ends, the fan will stop/start running automatically. To cancel, set the time to 0 hour. Note: Display will return to fan speed after 3 seconds.
Memory
If the fan is turned OFF or disconnected from power, it will operate under the previous settings (except the timer setting) when it is turned ON again. Long press ➕ and ➖ for 10 seconds to restore factory settings when the fan is in power-on or standby mode.
Display Auto Off
- Display turns off after 1 minute (after 5 seconds in sleep mode).
- Wake up the display with any button.
- To disable this feature, please go to the DREO app.
Getting the Most out of Your Tower Fan
- Remove any tall obstacles that might block the airflow from the fan.
- Combine with your AC unit to get cooler air throughout the room.
- Position the tower fan closer to you to get more direct airflow.
- Place a bucket of ice in front of the fan for an extra cooling boost.
06 CLEANING AND MAINTENANCE
Outer Surface: Gently wipe off the dust with a soft, dry cloth.
Grilles & Blades: Remove the dust using a vacuum or air duster.
Base: The base can be disassembled in the reverse order of assembly.
CAUTION
- Always unplug the fan before any cleaning or maintenance.
- Do not immerse in water or get water inside the motor housing.
- Do not use any chemical agents when cleaning the fan.
- Store in a cool, dry place and cover it to protect from dust.
Rear Grille
WARNING: Turn off the appliance and unplug before any cleaning and maintenance.
- Lay the Tower Fan facing down on a flat surface.
- Remove the screw at the bottom of the rear grille with a Philips screwdriver.
- Pull down the grille and take it out.
- Clean the dust on blades using a vacuum cleaner or air duster. Rinse the rear grille under running water with a clean, damp cloth.
- Dry up, then install the grille and the screw back by following the reverse order of disassembly.
07 TROUBLESHOOTING
My fan won't turn on!
Make sure that the cord is connected to a powered outlet and the mains voltage corresponds with the voltage indicated on the fan.
My fan is shaky and wobbling!
- Place the fan on a flat, level surface.
- Incorrect installation might also cause shakiness. Please refer to the assembly instructions in page 4-5. Note that the power cord must be run through all rear keepers.
My fan is making vibration and noise!
- Place the fan on a flat, level surface.
- Be sure not to insert anything into the air inlet and outlet.
If your problem is not listed or still persists, please contact Dreo Customer Support (see page 20).
08 DREO CUSTOMER CARE
24-MONTH LIMITED WARRANTY
What is Covered
Dreo warrants to you that your product will be free from original defects in materials and workmanship for a period of twenty-four (24) months from the date of your purchase, when you use your product for intended purposes in accordance with this User Manual.
Please retain your proof of purchase. If you do not retain your proof of purchase, your warranty will start two (2) months from the date of manufacture printed on your product label.
What is Not Covered
This limited warranty only applies to the original purchaser of your product and is non-transferable. This warranty is only valid if your product is used in the country in which you originally purchased it. In addition, this warranty will not apply, and Dreo will not be liable for any costs, damages, or repairs, in connection with any of the following:
- Accidents or use of your product with inappropriate force;
- Damage or destruction caused by wrong voltage or unstable electric current;
- Normal wear and tear;
- Careless operation or handling, misuse, abuse, neglect, and/or failure to maintain or use your product in accordance with this User Manual;
- Any partially or completely altered, modified and/or dismantled products;
- Reduction in battery discharge time due to battery age or use (as applicable);
- Products with altered or removed serial numbers;
- Clearing any blockages from the product;
- Purchases from retailers and distributors not authorized by Dreo to sell this product;
- Defects caused by or resulting from damages from shipping or handling by any third party not authorized by Dreo to ship or handle your product; or
- Defects caused by or resulting from repairs, service, improper maintenance, or alteration to your product or any of its components by anyone other than a repair person authorized by Dreo.
Any service and customer support that Dreo provides to you under this limited warranty will not extend the duration of this limited warranty.
Warranty Limitations and Exclusions
ANY IMPLIED WARRANTIES RELATING TO YOUR PRODUCT, INCLUDING BUT NOT LIMITED TO THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THE LIMITED WARRANTY SET FORTH ABOVE AND ARE OTHERWISE DISCLAIMED.
THIS LIMITED WARRANTY SHALL BE THE SOLE REMEDY OF THE PURCHASER OR USER OF THE PRODUCT, AND DREO SHALL NOT BE LIABLE FOR AN ALLEGEDLY DEFECTIVE OR DAMAGED PRODUCT EXCEPT TO REPAIR OR REPLACE IT IN ACCORDANCE WITH THIS LIMITED WARRANTY. DREO WILL NOT BE LIABLE FOR SPECIAL, INCIDENTAL, INDIRECT, CONTINGENT, OR CONSEQUENTIAL DAMAGES OR LOSSES OF ANY NATURE THAT YOU MAY INCUR IN CONNECTION WITH YOUR PURCHASE OR USE OF YOUR PRODUCT.
Some jurisdictions do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This limited warranty gives you specific legal rights, and you also may have other rights which vary from jurisdiction to jurisdiction.
Limited Remedies
If your product fails because of an original defect in material and/or workmanship during the warranty period, Dreo will repair or replace (in Dreo's sole discretion) your product.
To obtain warranty service on your product, contact Dreo at uk-support@dreo.com for further instructions.
IN THE EVENT OF AN ORIGINAL DEFECT IN MATERIAL AND/OR WORKMANSHIP, TO THE EXTENT PERMITTED BY LAW, THE REMEDIES SET FORTH IMMEDIATELY ABOVE ARE YOUR SOLE AND EXCLUSIVE REMEDIES.
Technical Specifications
Specification details | Symbol | Value | Unit |
---|---|---|---|
Maximum Fan Flow Rate | F | 39.55 | m³/min |
Fan Power Input | P | 31.5 | W |
Service Value | SV | 1.25 | (m³/min)/W |
Standby power consumption | PSB | 0.47 | W |
Fan Sound Power Level | LWA | 54.63 | dB(A) |
Maximum Air Velocity | c | 4.10 | meters/sec |
Nominal fan power input | PF | 0.0315 | kW |
Annual electricity consumption | Q | 10.606 | kWh/a |
Measurement Standard for Service Value | IEC 60879: 2019 |
Contact details for obtaining more information:
Manufacturer Name: Shenzhen Hesung Innovation Technology Co., LTD
Address: 26th Floor, Building A7, Chuangzhiyuncheng, Liuxian Avenue, Nanshan District, Shenzhen
We're Here to Help!
Model No.: DR-HTF018S Rev_1.1_UK