Delta Compel Collection
Care Instructions
Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
Installation Instructions
Tools Required
- 1/4" carbide drill bit
- Electric drill
- Phillips screwdriver
- Level
Installation Steps
1. Unscrew the set screw at the base of each post and remove mounting screws and brackets (if necessary).
2. Assemble both posts and the bar. Position on the wall where desired.
3. Lightly mark the outline of each post. Center the mounting brackets vertically within the outlines of the posts. Refer to Figure 1 for post views and mounting bracket placement.
4. Mark the location of the mounting screws. If mounting onto ceramic tile, try to locate the mounting hole locations on a grout line. However, the center-to-center measurement of the posts must be maintained as marked. Refer to Figure 2 for post spacing.
5. If mounting into ceramic tile, use masking tape on the mounting area before marking the location to prevent the drill bit from sliding across the tile.
6. To drill through ceramic tile, obtain a 1/4" diameter carbide drill bit.
7. Drill 1/4" holes and push anchors flush with the wall. Fasten the mounting brackets to the wall with mounting screws. Refer to Figure 1 for mounting screw and anchor details.
8. Place posts over the brackets and tighten the set screws.
Figure 1: Post Views and Mounting Details
Figure 1 illustrates different views of the post and mounting hardware. The 'Back View of Post' shows the general shape. The 'Front View' highlights the mounting screw holes. The 'Side View' shows the post from the side. Key components include:
- Post Outline: A traced outline of the post's surface.
- Mounting Bracket: The plate used to attach the post to the wall.
- Set Screw: A small screw used to secure the post to the bracket.
- Mounting Screws: Screws used to attach the bracket to the wall.
- Anchors: Fasteners used in walls to provide a secure point for mounting screws, especially in drywall or tile.
- Mounting Screw Holes: Pre-drilled holes on the post or bracket for screws.
Figure 2: Product Examples and Dimensions
Figure 2 displays various products from the Compel Collection with their respective model numbers and dimensions:
- Model 77118: An 18" (457mm) towel bar.
- Model 77124: A 24" (610mm) Towel Bar.
- Model 77135: A Robe Hook, with a mounting bracket and screw hole spacing of 0.83" (21mm).
- Model 77146: A Towel Ring, with a mounting bracket and screw hole spacing of 0.83" (21mm).
- Model 77150: A Toilet Paper Holder, 6" (152mm) in length, with a mounting bracket and screw hole spacing of 0.83" (21mm).
Delta Faucet Company Lifetime Bath Accessories and Finish Limited Warranty
All parts and finishes of the Delta bath accessories are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns her/his home.
Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish which proves defective in material and/or workmanship under normal installation, use, and service. Replacement parts may be obtained by calling 1-800-345-DELTA or by writing to:
Delta Faucet CompanyProduct Service
55 E. 111th Street
Indianapolis IN 46280
This warranty is extensive in that it covers replacement of all defective parts and even finish, but these are the only two things that are covered. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION, REPAIR, OR REPLACEMENT AS WELL AS ANY OTHER KIND OF LOSS OR DAMAGE ARE EXCLUDED.
Proof of purchase (original sales receipt) from the original consumer purchaser must be made available to Delta for all warranty claims. THIS IS THE EXCLUSIVE WARRANTY BY DELTA FAUCET COMPANY, WHICH DOES NOT MAKE ANY OTHER WARRANTY OF ANY KIND, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY.
This warranty excludes all industrial, commercial, and business usage. For such usage, purchasers are extended a five-year limited warranty from the date of purchase, with all other terms of this warranty applying except for the duration. This warranty is applicable only to Delta® bath accessories made after January 1, 1995.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to this bath accessory as a result of misuse, abuse, or neglect, or any use of other than genuine Delta® replacement parts WILL VOID THE WARRANTY.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. It applies only for Delta® bath accessories installed in the United States of America, Canada, and Mexico.
