ASSEMBLY AND INSTALLATION INSTRUCTIONS

Important Safety Information

WARNING: Turn off the main power at circuit breaker before installing fixture.

NOTE:

• Before installing, consult local electrical codes for wiring and grounding requirements.
• READ AND SAVE THESE INSTRUCTIONS.

Hardware Package

The following hardware is included:

• Mounting Plate Unit (A)
• Mounting Screw (B)
• Wire Connector (C)
• Bolt Nut (D)
• Rubber Pad (E)

[Diagram Description: This diagram shows the contents of the hardware package, including: a circular Mounting Plate Unit (A), two Mounting Screws (B), three Wire Connectors (C), two Bolt Nuts (D), and two Rubber Pads (E).]

Fixture Assembly and Wiring Diagram

[Diagram Description: This diagram illustrates the assembly process. It shows an Outlet Box with House Grounding Wire and Fixture Grounding Wire. A Mounting Plate Unit (A) is attached to the outlet box using Mounting Screws (B). Headless Screws are also shown. The fixture's Backplate is then attached to the Mounting Plate Unit (A) using Rubber Pads (E) and Bolt Nuts (D). Fixture Wires and Wire Connectors (C) are used to connect the fixture to the power source wires. A note indicates the maximum bulb wattage is 60W for a Type A bulb, which is not included.]

Installation Steps

1. Turn off the power at fuse or circuit box.

   Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.

2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled headless screws if necessary.

   Note: Make sure that two headless screws are lined up horizontally to make the fixture level.

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

   • Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
   • Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
   • Attach the fixture grounding wire (usually green with the insulation or bare wire) to the mounting plate unit (A) with green grounding screw. Then, depending on local code, connect it to the house grounding wire with the wire connector (C).

   Carefully put all of the wires back into the outlet box.

4. Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.

5. Attach the backplate of the fixture to the mounting plate unit (A) by aligning and inserting the two headless screws into set holes on backplate, then secure it with two rubber pads (E) and two bolt nuts (D).

   Note: With silicone caulking compound, caulk completely around where the backplate meets with the wall surface to prevent water from seeping into the outlet box.

6. Turn on the power at fuse or circuit box.

Spare Parts List

The following parts are available for re-order if damaged or missing:

• Mounting Plate Unit (A)
• Mounting Screw (B)
• Wire Connector (C)
• Bolt Nut (D)
• Rubber Pad (E)

Assembly Kits:

• 6495MM (1 SET) for T0638
• 6496MM (1 SET) for T0639

[Diagram Description: This diagram visually lists the spare parts available for re-order, matching the labels A through E from the hardware package. It also details the available Assembly Kits: 6495MM (1 SET) for model T0638 and 6496MM (1 SET) for model T0639.]

Fixture Dimensions

[Diagram Description: This diagram shows the overall dimensions of the fixture, labeled A, B, and C, with corresponding measurements: A is 6-1/4 inches, B is 6-1/2 inches, and C is 7-1/4 inches.]