The ATN Genoa Sleeve

To install the ATN Genoa Sleeve:

1. Furl the genoa tightly.
2. Attach the spinnaker halyard to the head of the genoa sleeve.
3. Close the genoa sleeve around the furled headsail with the zipper and close the safety lock.
4. Fasten the zipper's slider pennant on the life line.
5. Hoist the genoa sleeve until the genoa sleeve leaves the deck.
6. Fasten the bottom of the genoa sleeve to the top of the roller furler drum with the hank.
7. The slider of the zipper will stop at the genoa sheets.
8. Engage and slide the bottom zipper slider up to the genoa sheets.
9. Pull on the tightening lines to gather the genoa sleeve: start with the double lines, cleat them, then pull on the center line, cleat it, then put the excess line inside the pocket.
10. Close the Velcro straps around the genoa sleeve.

To remove the ATN Genoa sleeve:

1. Slack the spinnaker halyard.
2. Undo the Velcro straps.
3. Uncleat the lines.
4. Pull the ATN genoa sleeve down.

You can watch the video on the website:

http://atninc.com/atn-genoa-sleeve-sailing-equipment.shtml