Royal Gourmet PD1302 Portable 3-Burner Gas Griddle

FOR YOUR SAFETY!

Use outdoors only! Do not use it inside a building, garage, or any other enclosed space.

Read the instructions before assembling and using the appliance.

DO NOT use the griddle unless it is completely assembled, and all the parts are securely fastened. This griddle will become very hot, do not move it during use. Keep away from children and pets.

[CSA Certified Mark US]

[Design Certified Mark]

CONTACT US FIRST!

This griddle has been made to high quality standards.

If you have any questions that are not addressed in this Owner's Manual, or you need parts, please call our customer service hotline or send an email to service@royalgourmetusa.com

Customer Service: ? 1-800-618-6798

Please keep this Owner's Manual for future reference.

Learn more at: www.royalgourmetcorp.com

[Social Media Icons: Facebook, Twitter]

Preparation

Before beginning assembly, make sure all parts are present. Compare parts with packaged contents list and diagram above. If any parts are missing or damaged, do not attempt to assemble the products. Contact customer service for replacement parts via telephone or email.

Tools Required:

• Phillips screwdriver (not included)
• Wrench (not included)

Illustration Description: A Phillips head screwdriver and an adjustable wrench are shown.

Estimated assembly time: 10 minutes

Note: The right and left sides of the griddle are designed as if you are facing the front of the griddle.

⚠️ CALIFORNIA PROPOSITION 65 WARNING

1. Fuels used in gas burning appliances and the combustion byproducts of such fuels, can expose you to chemicals including carbon monoxide, which is known to the State of California to cause birth defects or other reproductive harm.

2. This product contains Nickel (Metallic) known to the State of California to cause cancer.

3. This product contains Lead and Lead Compounds known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information, go to: www.P65Warnings.ca.gov

Parts and Hardware List

Assembly Instructions

Step 1

Assemble 4 leg base assemblies (1) to the bottom of the main body (2) by twisting clockwise until tightened.

Diagram Description: Shows the main body (2) upside down, with four leg base assemblies (1) being attached to the corners using a twisting motion indicated by circular arrows.

Step 2

Insert the grease cup (4) to the side of the main body. Screw 4 studs (3) underneath the cooking griddle (5). Adjust the nuts to ensure the flatness of the griddle. It is recommended to leave a few inches of space from each nut to the griddle, as shown in the figure.

Diagram Description: Shows the main body with the cooking griddle (5) placed on top. The grease cup (4) is being inserted into a side slot. Studs (3) are shown being screwed into the underside of the griddle, with nuts being adjusted for flatness. A measurement of "4mm" is indicated for the space between the nut and the griddle.

Step 3

Connect the regulator (6) to the main body.

Diagram Description: Shows the regulator (6) with its fitting being connected to the gas inlet on the main body of the griddle.

Step 4

Insert the nipple of the regulator into the 1 lb. LP tank (not included) and hand tighten it by twisting clockwise as shown.

Diagram Description: Shows the regulator hose connecting to a 1 lb LP tank. A hand is shown tightening the connection clockwise.

Step 5

Before use, conduct the LP tank leak test as shown.

Diagram Description: Illustrates the leak test procedure. It shows a mixture of soap and water being applied to the gas connections. Bubbles forming would indicate a leak.

Step 6

Consider to manually light the burner with a lit match stick as shown if failing to light the burner with piezo ignition.

Diagram Description: Shows a lit matchstick being used to ignite a burner. This is an alternative to the built-in piezo ignition.