Siemens 9410SK Sealing Kit

Safety Precautions

DANGER / PELIGRO / DANGER / GEFAHR

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E in the USA or applicable local standards.
• Turn off all power supplying this device and the equipment in which it is installed before working on the device or equipment.
• Always use a properly rated voltage sensing device to confirm that all power is off.
• Do not exceed the device's ratings for maximum limits.

Failure to follow these instructions will result in death or serious injury.

(Safety instructions are also provided in Spanish, French, German, Italian, Portuguese, Russian, and Chinese in the original document.)

Installation Safety Steps

1. Turn off all power supplying this device and the equipment in which it is installed before working on the device or equipment.
2. Always use a properly rated voltage sensing device to confirm that all power is off.

Meter Covers

The sealing kit is used for various meter covers:

Sealing Wire: 2 mm (0.08) max sealing wire - customer supplied.

Installation Procedure

Voltage Inputs Sealing

This procedure describes how to seal the voltage inputs.

Steps:

1. Remove the existing sealing cover for voltage inputs.
2. Apply the new sealing cover (B) to the voltage inputs (A) at the sealing point (C).

Components:

• A: Voltage inputs
• B: Sealing cover
• C: Sealing point

Current Inputs Sealing

This procedure describes how to seal the current inputs.

Steps:

1. Remove the existing sealing cover for current inputs.
2. Apply the new sealing cover (B) to the current inputs (A) at the sealing points (C).

Components:

• A: Current inputs
• B: Sealing cover
• C: Sealing points (2)