Assembly Instruction
Model: 42942122 SIDE TABLE THRONE
Care Instructions
Wipe clean with a dry cloth. Do not use abrasive materials and solvents. Check and tighten all parts regularly. Keep away from water and direct sunlight. Store in a dry place. For domestic use only. For indoor use only.
Warning ⚠️
Do not stand or sit on this unit. Do not use this unit unless all bolts and screws are firmly secured. Do not knock or drag this unit. Use only on a flat surface. Adult assembly required. Failure to follow these warnings could result in serious injury. This package contains small parts and sharp points. Keep away from children and babies.
Maximum Safe Load
20Kgs for top panel, 7Kgs for shelf.
Hardware List
| Item | Description | Quantity |
|---|---|---|
| a | 4x55mm screw | 8pcs |
| b | 6x30mm screw | 8pcs |
| c | 4x25mm screw | 16pcs |
| d | 6x55mm screw | 8pcs |
| e | Connector/Dowel | 4pcs |
Assembly Steps
Step 1:
Attach side panels (3) to the top panel (1) and shelf panel (2) using screws 'a' (8 pieces) and screws 'b' (8 pieces). The diagram shows the top panel (1) and shelf panel (2) with four side panels (3) being attached from the sides. Screws 'a' are shown securing the top panel, and screws 'b' securing the shelf panel.
Step 2:
Attach the cross braces (4) to the side panels (3) using screws 'c' (16 pieces). The diagram shows the partially assembled frame. Four cross braces (4) are positioned horizontally between the side panels (3), forming a rectangular frame. Screws 'c' are shown securing these braces.
Step 3:
Attach the legs (5) to the bottom of the side panels (3) using screws 'd' (8 pieces). The diagram shows the frame upside down. Four legs (5) are being attached to the bottom corners of the side panels (3). Screws 'd' are shown going into the legs.
Step 4:
Insert the connectors/dowels (e) into the designated holes on the top of the legs (5). The diagram shows the assembled table with pieces labeled 'e' being inserted into the top of the legs (5).
Important Note: Do not tighten the screws fully during assembly. Fully tighten screws after the final assembly steps.
Final Product View
The final image shows the completed side table with a top surface and a lower shelf, supported by four legs.
