Instruction Manual for Wild Land models including: S14-YXDC-01, 2BGBC-S14-YXDC-01, 2BGBCS14YXDC01, S14 String Light with Speaker, S14, String Light with Speaker, Light with Speaker, Speaker, Light
WildLand International Inc. S14-YXDC-01 S14 string light with speaker 2BGBC-S14-YXDC-01 2BGBCS14YXDC01 s14 yxdc 01
S14 string light with speaker DC 12V() DC DC12V 2A() () 8.8W2.8W+6W) 0 5 -10°C~50°C 3W x 2 "S14 SPEAKER BULB SYNC"S14 5S14 S14 string light with speaker Two light strings connected Light bulb Speaker 8.8W (light 2.8W+speaker 6W) (Single lamp) DC 12V power supply (non-standard) DC male cable DC12V 2A(Single light string) adapter (non-standard) Extension cord 0 5 x 2 Search for the bluetooth device named "S14 SPEAKER BULB SYNC" by your phone or other audio source device, S14 will work as the phone's audio output device after connecting. Within 5 meters, the audio device which connect to the phone will work as the main device, any other S14 device will work as the sub device to synchronize with the main device when it's power on. Note: The main device should be installed in the middle of the string light to avoid bad signals, If there is no any sounds after the power on, please make sure that the device is tightened and try again, There are related tones when the device is power on and be connected or disconnected to the phone. S14 string light with speaker FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.Adobe Illustrator(R) 16.0 Adobe PDF library 10.01