DD3000H / DD3001H Emitter Instruction
Control System: Radio+
Version: A/01
Instruction Of Buttons
The emitters DD3000H (Single-channel) and DD3001H (5-channel) have the following buttons:
- UP/OPEN: Opens or moves upwards.
- STOP: Stops the current operation.
- DOWN/CLOSE: Closes or moves downwards.
- CH (on DD3001H): Channel selection button.
- Setting button (P2): Used for mode switching and lock/unlock operations.
Each button is associated with an LED indicator.
Technical Specification
| Specification | Details |
|---|---|
| Battery | 3V (AAA battery x 2) |
| Working temperature | -10°C to 50°C |
| Battery life | 2 years |
| Transmitting power | 10 mW |
| Radio frequency | 433.05-434.79MHz |
| Radio range | Outdoor: > 150 meters, Indoor: > 35 meters |
Warning
- Avoid exposing the emitter to moisture or heavy impacts to maintain its lifespan.
- If the emitter becomes less sensitive or the radio range decreases, check and replace the battery.
- In uni-directional mode, pressing any button for more than 20 seconds will stop radio signal transmission.
- In bi-directional mode, pressing STOP and P2 for more than 20 seconds, or UP and DOWN for 2 minutes, will stop radio signal transmission.
- Do not use different types of batteries together to avoid dangerous risks.
- Dispose of used batteries properly.
Uni-directional / Bi-directional Mode Switch
Note: Both P2 buttons on the back are operable. The factory default mode is Bi-directional. Repeat the operation to switch modes.
- To switch to Uni-directional mode: Hold the P2 button and install the battery. The LED will flash once.
- To switch to Bi-directional mode: Hold the P2 button and install the battery. The LED will flash twice.
Combination Button Lock/Unlock Operation
Note: Both P2 buttons on the back are operable. The factory default is unlock status. Repeat the operation to switch status.
- If there is no operation for 10 seconds, the emitter will automatically exit the setting status.
- When combination buttons are locked, pressing them will not send any signal and the LED will not flash. Only the transmitting code is affected.
To lock the combination buttons: Press and hold the STOP button for more than 15 seconds. The LED will flash slowly for 3 seconds. (P2 pressed once also indicated).
To unlock the combination buttons: Press and hold the STOP button for more than 15 seconds. The LED will flash quickly for 3 seconds. (P2 pressed once also indicated).
