Thermos EHAI-5607E Milk Frother

Introduction

This manual applies to the Thermos EHAI-5607E Milk Frother. Read the manual carefully before using the product. After reading, keep the manual in a place where others can access it at any time.

Precautions for Safe Use

Read all instructions before using and only use this appliance as directed. Failure to follow these important safeguards may result in injury and/or property damage and will void your warranty. When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons.

1. DO NOT place the appliance on or near a hot gas or electric burner, or in a heated oven.
2. DO NOT let the power cord touch hot surfaces or open flame, including the stovetop.
3. DO NOT connect appliance to an outlet below counter.
4. DO NOT use this frother outdoors.
5. DO NOT let the frother operate without milk.
6. DO NOT use the appliance for anything other than its intended use.
7. NOT for commercial use. For household use only.
8. DO regularly inspect the appliance and power cord.
9. DO fill the pitcher with only water, milk or non-dairy milk alternatives. Never fill the pitcher with oil or other liquids.
10. DO NOT leave the appliance exposed to sun, wind, and/or snow.
11. DO operate and store the appliance above 32°F/0°C.
12. DO NOT leave the appliance unattended when in use.
13. DO NOT allow children operate the appliance; close supervision is required when any appliance is used near children.
14. DO NOT let children play with this appliance.
15. To avoid the risk of personal injury or damage to property, DO NOT open the top cover during the foaming, frothing or warming process.
16. There are extremely hot liquids within the unit during the foaming, frothing and warming process.
17. The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
18. Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
19. DO unplug from outlet when not in use before cleaning. Allow the appliance to cool before putting on or taking off parts, and before cleaning the appliance.
20. DO NOT store any materials in the frother when not in use.
21. This appliance has a polarized plug. To reduce the risk of electric shock:
22. DO NOT attempt to modify the plug. If the plug does not fit full into the outlet, reverse the plug.
23. DO plug this appliance into a polarized outlet one way. This appliance has a polarized plug, and one blade is wider than the other.
24. DO contact a qualified electrician if the plug does not fit in the outlet.
25. The unit contains electrical components that are an electrical shock hazard.
26. Failure to follow these instructions may result in electric shock.
27. DO NOT use with power converters or adapters, timer switches or separate remote control systems.
28. DO disconnect the appliance by first pressing the cancel button, and then grasping the plug and pulling from the outlet. Never pull from the power cord.
29. DO keep appliance and cord away from children.
30. To reduce the risk of fire or electric shock, DO NOT remove the bottom cover. No user-serviceable parts inside. Repair should be done by authorized service personnel only.
31. DO regularly inspect the appliance and power cord. DO NOT operate the appliance if the power cord or plug is damaged, or after the appliance malfunctions or is dropped or damaged in any manner.
32. DO NOT attempt to repair, replace or modify components of the appliance, as this may cause electric shock, fire or injury, and will void the warranty.
33. DO NOT tamper with any of the safety mechanisms, as this may result injury or property damage.
34. To protect against electrical shock DO NOT immerse power cord, plug or the appliance in water or other liquid.
35. DO NOT use the appliance in electrical systems other than 120V~60Hz for North America.

SAVE THESE INSTRUCTIONS

Product Parts and Instructions

Package Contents

• (Detachable) Frothing paddle
• Heating paddle
• Detachable Brush
• Lid
• Sealing Ring
• Pitcher
• Control Panel
• Power Base

Note: The heating paddle is fixed inside the pitcher and cannot be removed.

How to Use

It's important to clean the components before you begin frothing.

1. Remove the lid from the pitcher, put it aside.
2. Gently pull up on the frothing paddle at the bottom of the pitcher.
3. Hand wash and rinse the lid and frothing paddle with dish soap and warm water.
4. Without immersing the pitcher in water, wash and rinse the inside of the frothing pitcher with dish soap and warm water.
5. Dry the lid, frothing paddle and pitcher with a soft, dry cloth.
6. Once dry, place the frothing paddle back into the pitcher by positioning the square end of the frothing paddle over the shaft at the bottom of the pitcher, and rotating the paddle until it aligns with the shaft, then push down paddle until it is secure.

Now you're ready to start making froth for your favorite drinks!

You can toggle between the programs to create different types of foams, perfect for your drinks. Stops and selected program.

Milk Frother Modes

For Non-Dairy Milk

The Thermos Milk Frother allows you to make both light and thick froth, warm or cold, with dairy and dairy-free milks. However, not all milk alternatives produce foam.

Use oat or soy milk when using the warm or cold foam setting. Coconut milk will only produce foam with the cold foam setting. Keep in mind that frothing dairy-free milks may not produce the same results as dairy milk.

How to Froth Milk

Attention:

• Always use the freshest, coldest milk or milk alternative possible for best results.
• When frothing large quantities of milk, allow the frother to rest for 3 minutes after every 2 frothing cycles.

1. Ensure the froth paddle is securely in place at the bottom of the pitcher. (See Figure 1)
2. Remove the lid from the pitcher and pour your choice of milk into the pitcher. (See Figure 2)

Figure 1 Description: Shows the frothing paddle correctly seated at the bottom of the pitcher, with markings for MAX and MIN fill levels.

Figure 2 Description: Illustrates pouring milk into the pitcher, with a note that refrigerated milk is better.

Important Note: Do not overfill the pitcher as this may cause the milk frother to overflow when using a foam setting. Ensure that milk is below the MAX line.

3. Place the lid on the pitcher and press down until secure.

How to Heat Milk

1. Take out the frothing paddle from inside the pitcher. (See Figure 3)
2. Repeat steps 2-7 from the "How to Froth Milk" section.

Figure 3 Description: Shows the frothing paddle being removed from the pitcher.

Warning: Ensure that milk is below MAX line, otherwise it may overflow.

Tips for Using

1. Using whole milk with a fat content of 3% is the best choice. Low fat or skim milk does not foam well.
2. Refrigerated milk has a better foaming effect.
3. If you are not satisfied with the first milk foam, do not try to make foam from the same milk, otherwise the milk may be burnt.
4. Always use fresh milk. Do not use milk that has been stored in containers for a long time.
5. Do not reheat the cooled milk and pour out the old milk.

WARNING

• The unit should not be operated with an external timer or a separate remote control system.
• Only fill the container up to the interior MAX marking. If you pour in too much milk, it can boil over and cause burn injuries and property damage.
• Only operate the milk frother with the lid on and do not remove the lid when the appliance is being used. Otherwise milk can escape and cause burn injuries and property damage.
• At least fill the container up to the MIN marking with milk.

Cleaning and Maintenance

Clean your milk frother after every use to ensure the best frothing results, and also prevent milk residue causing burning on the pitcher inside. Always unplug the milk frother and let it cool to room temperature before cleaning.

DO NOT use metal scouring pads, abrasive powder or harsh chemical detergents to clean the milk frother or any of its components. Let all parts dry thoroughly before use or before storage.

WARNING: The pitcher and base contain electrical components. To avoid fire, electric shock or personal injury, DO NOT machine wash, rinse or immerse the milk frother base, pitcher, power cord plug in water or other liquids.

Product Specifications

Troubleshooting

The following troubleshooting guide addresses the most common problems.