VTech DM1111 Digital Audio Monitor

Getting Started

Congratulations on purchasing your new VTech product. Please read the Important Safety Instructions before use. This manual provides all necessary feature operations and troubleshooting for your new VTech product.

What's in the Box

• Baby Unit
• Parent Unit
• 2 x Rechargeable Batteries (1.2V AAA 400mAh Ni-MH)
• 2 x Power Adapters
• User's Manual

Install Batteries for Temporary Use

For normal use, it is recommended to power the parent unit using the power adapter. For portability, install the provided rechargeable batteries. Use only the provided rechargeable batteries (1.2V AAA 400mAh Ni-MH). Do not mix old and new batteries, or different types of batteries (alkaline, standard, rechargeable). Ensure correct polarity when inserting batteries. The parent unit turns on when batteries are installed. Replace batteries when the low battery light flashes or the unit beeps twice every 10 minutes.

1. Press down on the battery compartment cover to slide it out.
2. Insert the rechargeable batteries into the battery compartment, observing polarity (+ and -).
3. Slide the battery compartment cover back into place until it clicks.

Replace Battery

To replace batteries, slide open the battery compartment cover, remove old batteries, and install new ones following the steps above.

Connect the Baby Monitor

Use only the supplied power adapters. Ensure adapters are oriented correctly and cords are out of reach of children. Both the baby unit and parent unit turn on when connected to power.

Notes:

• Ensure the POWER / LINK light is on after fully inserting the parent unit's power plug.
• Ensure the baby unit is on. If the parent unit is not linked, the POWER / LINK light will flash. Move the parent unit closer to the baby unit (minimum 6.5 feet / 2 metres).
• Ensure the POWER light is on after fully inserting the baby unit's power plug.

Operation

Charge the Parent Unit Battery

The parent unit powers on automatically when connected and its battery is installed for the first time or after a power outage. The battery is fully charged after 16 hours of continuous charging. Charging time is shorter if the parent unit is turned off. Standby time varies with volume, usage, and battery age.

Before Use

Note: This baby monitor is an aid and not a substitute for proper adult supervision.

Test Your Baby Monitor

Test the monitor before initial use and regularly thereafter.

Caution: For hearing protection, keep the parent unit more than 6.5 feet (2 metres) away from the baby unit. If you hear high-pitched noise, move the parent unit further away or press the [VOLUME DOWN button] to lower or mute the noise.

1. Ensure both baby unit and parent unit are on.
2. Speak towards the baby unit's microphone. You should hear the sound on the parent unit and see the visual sound indicators light up.

Note: If the POWER/LINK LED light flashes, move the parent unit closer to the baby unit (maintain minimum 6.5 feet / 2 metres distance) and check power connections.

Tip: Increase parent unit speaker volume if sounds from the baby unit are not audible.

Positioning the Baby Monitor

Caution: Keep the baby unit out of the baby's reach. Never place or mount the baby unit inside a cot or playpen.

1. Place the baby unit more than 3 feet (1 metre) away from your baby.
2. Place the parent unit more than 6.5 feet (2 metres) away from the baby unit.

Caution: If you experience high-pitched screeching noise, ensure units are more than 6.5 feet (2 metres) apart or turn down the parent unit's volume.

Operating Range

The operating range is up to 1,500 feet (450 metres) outdoors or 160 feet (50 metres) indoors. Actual range depends on environmental conditions and obstructions like walls.

Overview

Baby Unit Overview

1. [ON/OFF button]: Press and hold to turn the baby unit on or off.
2. [Microphone]
3. [POWER light]
4. [Power jack]

Parent Unit Overview

1. [Speaker]
2. [ON/OFF button]: Press and hold to turn the parent unit on or off.
3. [VOLUME UP button]: Press to increase speaker volume.
4. [POWER/LINK light]
5. [Power jack]
6. [Visual sound indicator]: Indicates sound level detected by the baby unit or shows speaker volume level.
7. [VOLUME DOWN button]: Press to decrease speaker volume. Press repeatedly to mute.
8. [Low battery light]
9. [Belt clip]
10. [Battery compartment cover]

Unit Lights

Baby Unit Light

• [POWER light]: Off when the baby unit is off. Green when the baby unit is on.

Parent Unit Lights

• [POWER/LINK light]: Off when the parent unit is off. Green when on and linked to the baby unit. Flashes green when there is no link or the parent unit is out of range.

Visual Sound Indicator

This indicator shows sound level detected by the baby unit and speaker volume level.

• Sound level detected: 1-3 green lights indicate moderate sound. Additional red lights indicate higher sound (e.g., baby crying).
• Speaker volume level: 1-3 green lights indicate Level 1-3. Additional red lights indicate Level 4-5. Flashes red when the battery is low.

Parent Unit Alert Tones

• Low battery tone: Beeps twice every 10 minutes when the battery is low.
• Out of range tone: Beeps three times every 30 seconds when the baby unit is out of range or not linked.

Using the Baby Monitor

Power On or Off the Baby Unit

• Press the [ON/OFF button]. The [POWER light] turns on.
• Press and hold the [ON/OFF button] until the [POWER light] turns off.

Power On or Off the Parent Unit

• Press and hold the [ON/OFF button] until the [POWER/LINK light] turns on.
• Press and hold the [ON/OFF button] until the [POWER/LINK light] turns off.

Adjust Speaker Volume

The speaker volume is preset to Level 3. Adjust to your preference using the [VOLUME UP button] and [VOLUME DOWN button]. The unit beeps twice if you press beyond the minimum or maximum setting. To mute, press [VOLUME DOWN button] repeatedly until silent. The visual sound indicator remains active when muted. Press again to unmute.

Product Care and Troubleshooting

General Product Care

• Avoid placing near heating appliances or devices generating electrical noise (motors, fluorescent lamps).
• Do not expose to direct sunlight or moisture.
• Avoid dropping or rough handling.
• Clean with a soft cloth.
• Do not immerse units in water or clean under a tap.
• Do not use cleaning spray or liquid cleaners.
• Ensure units are dry before connecting to mains power.

Storage

If storing for an extended period, remove the rechargeable batteries from the parent unit. Store the parent unit, baby unit, and adapters in a cool, dry place.

Frequently Asked Questions (FAQ)

• Why doesn’t the POWER light on the baby unit turn on? Ensure the baby unit is connected to power.
• Why doesn’t the POWER/LINK light on the parent unit turn on? Ensure the parent unit is connected to power and batteries are installed and charged.
• Why does the baby monitor not respond normally? Try power cycling both units, removing batteries, reconnecting power, and allowing up to one minute for synchronization. Adjust volume if necessary.
• Why does the baby monitor produce a high-pitched noise? Ensure units are at least 6.5 feet (2 metres) apart.
• Why don’t I hear a sound or my baby cry? Ensure units are on. Check if volume is muted or too low. If visual indicators show sound but no audio, increase volume. If indicators do not light up, the baby's sound may be too low for detection, which is normal. Position the baby unit at least 6.5 feet (2 metres) away from the baby.
• Why does the parent unit beep? It beeps three times every 30 seconds when out of range (move closer). It beeps twice every 10 minutes with a flashing red light when the battery is low (connect to power).
• Why does the parent unit light flash? The light flashes red when the battery is low; connect to power to charge.
• Why can’t I establish a connection, or why is the connection lost/interrupted? The baby unit may be out of range (move closer). Other electronic devices may cause interference; place the monitor as far as possible from them.

Safety and Compliance

Important Safety Instructions

1. Follow all product warnings and instructions.
2. Adult setup is required.
3. Caution: Do not install the baby unit higher than 2 metres.
4. This product is an aid, not a substitute for adult supervision.
5. This product is not a medical monitor.
6. Do not use near water (bath tub, sink, pool, wet basement, shower).
7. Caution: Use only the provided battery (1.2V AAA 400mAh NiMH). Incorrect batteries may pose an explosion risk. Avoid extreme temperatures and low air pressure during use, storage, or transport. Dispose of batteries according to instructions; do not incinerate, crush, or cut.
8. Use only the supplied adapters (Ten Pao Industrial Co.,Ltd. Model: S003ATV0600045 (EU), S003ATB0600045 (UK)). Incorrect voltage or polarity can damage the product.
9. Ensure adapters are oriented correctly and not used in ceiling, under-table, or cabinet outlets.
10. For pluggable equipment, the socket-outlet should be near the equipment and easily accessible.
11. Unplug before cleaning. Use a damp cloth; do not use liquid or aerosol cleaners.
12. Do not cut off power adapters to replace them; this creates a hazard.
13. Do not place anything on power cords and avoid placing cords where they can be walked on or crimped.
14. Operate only from the indicated power source type. Consult a dealer or power company if unsure.
15. Do not overload wall outlets or use extension cords.
16. Do not place on unstable surfaces.
17. Ensure proper ventilation; do not block openings. Keep away from radiators or heat registers.
18. Never insert objects into product slots, as they may touch dangerous voltage points or cause short circuits. Never spill liquids on the product.
19. To reduce electric shock risk, do not disassemble. Take to an authorized service facility. Incorrect reassembly can cause electric shock.
20. Test sound reception when turning on units or moving components.
21. Periodically examine components for damage.
22. Be aware of potential privacy loss with electronic devices. Reset the monitor periodically by powering off/on, and power off when not in use.
23. Supervise children to ensure they do not play with the product.
24. The product is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience, unless supervised by a responsible person.

SAVE THESE INSTRUCTIONS

Cautions

1. Use and store the product between 0°C and 40°C.
2. Do not expose to extreme cold, heat, or direct sunlight. Keep away from heating sources.
3. Batteries should not be exposed to excessive heat.
4. Ensure baby unit(s) and adapter cord(s) are out of the baby's reach, at least 1 metre away from the baby or cot, to avoid strangulation hazards.
5. Never place baby unit(s) inside a cot or playpen. Never cover units with towels or blankets.
6. Other electronic products (routers, radios, phones, TVs, computers, etc.) may cause interference. Install the monitor as far away from them as possible.

Disposal of Batteries and Product

The [crossed-out wheelie bin symbol] on products and batteries indicates they must not be disposed of in domestic waste due to environmentally damaging substances. Chemical symbols Hg, Cd, or Pb indicate battery content exceeding limits set by Directive 2006/66/EC. A solid bar indicates the product was marketed after August 13, 2005. Dispose of products and batteries responsibly to protect the environment.

Declaration of Conformity

This product complies with essential requirements of the EU's Radio Equipment Directive (2014/53/EU) and UK's Radio Regulations 2017. The Declaration of Conformity for DM1111 is available at www.vtechbabycare.com.

Warranty and Support

Customer Service and Product Warranty

Please retain your sales receipt as proof of purchase. For customer service, call 03306 780149 (UK) or +44 3306 780149 (outside UK). This warranty is valid for the UK and Eire only. For other regions, contact your local distributor.

Product Warranty: This product is covered by a one-year warranty against defects in materials or workmanship. It can be returned to the place of purchase or VTech Electronics Europe plc with proof of purchase. VTech will replace defective products at their discretion. The warranty is void if the product is damaged due to misuse, modification, unauthorized repair, faulty batteries, or incorrect connections. It is personal to the original purchaser and non-transferable. LCD screen breakages are not covered. Returns to VTech require a £1.50 cheque/postal order for postage and packaging. Register your product online at www.vtech.co.uk/warranty.

Technical Specifications

Credits

• Background Noise sound file: Caroline Ford (Creative Commons license)
• Stream Noise sound file: Caroline Ford (Creative Commons license)
• Crickets At Night sound file: Mike Koenig (Creative Commons license)
• Heart Beat sound file: Zarabadeu (Creative Commons license)

Specifications are subject to change without notice. © 2021 VTech Telecommunications Ltd. All rights reserved. 02/21. DM1111_UK_CIB_V5