Aosu Battery-Powered Video Doorbell and Chime SE
Quick Start Guide
I. What's Included
The package contains:
- 1. Video Doorbell (V8E2CA11)
- 2. Screw Pack
- 3. USB-C Charging Cable
- 4. Mounting Bracket
- 5. Quick Start Guide
- 6. Doorbell Chime (H3L2CA11)
II. Product Overview
The video doorbell unit includes:
- 1. Lens
- 2. PIR Motion Sensor
- 3. Microphone
- 4. Infrared LEDs
- 5. Status LED
- 6. Reset Button
- 7. Power ON/OFF button
- 8. Micro SD Card Slot
- 9. USB-C Port
- 10. Speaker
- 11. Release clip
Capacity Requirements: 8-128GB
Read and Write Speed Requirements: Class 10
File Format: FAT32
III. System Setup
To set up your Aosu Video Doorbell:
- Download the Aosu App from the App Store (iOS devices) or Google Play (Android devices).
- Sign up for an Aosu App account.
- Follow the onscreen instructions to complete the setup.
IV. Mounting the Camera
Height and Location:
- The recommended mounting height is 1.2-1.5 meters (48-59 inches) from the ground.
- The optimal motion detection distance is 7 meters (23 feet).
Camera Installation:
- Attach the mounting bracket to the wall with screws.
- Align the doorbell with the catches on the bracket and push downwards until it clicks into place.
Camera Removal:
- Press the release clip with your finger.
- Grasp the doorbell and pull upwards to remove it.
Chime Installation
The chime requires a power connection:
- 1. AC 110V-240V power input
- 2. Music Switch Button
- 3. Speaker
V. Notice
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- (1) Reorient or relocate the receiving antenna.
- (2) Increase the separation between the equipment and receiver.
- (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- (4) Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in fixed/mobile exposure conditions. The minimum separation distance is 20cm.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC RF Statement
This equipment complies with IC RSS - 102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR - 102 établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
Declaration of Conformity
Aosu declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://www.aosulife.com. This product can be used across EU member states.
Do not use the Device in environments with excessively high or low temperatures. Never expose the Device to strong direct sunlight or excessively humid environments.
The suitable temperature for the Camera and accessories is -10°C to 50°C.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirements, use products that maintain a 20cm distance between the device and human body.
For Camera: Wi-Fi Operating Frequency Range: 2412~2472MHz; Wi-Fi Max Output Power: 17.13dBm(EIRP)
This product is designed and manufactured with high quality materials and components, which can be recycled and reused.
This symbol ♻️ means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment.
For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
VI. Customer Service
Warranty: 12-month limited warranty. The actual warranty period shall be implemented according to the requirements of local laws and regulations.
Contact Information:
- Email: support@aosulife.com
- Phone (USA): +1-866-905-9950 (Mon-Fri 9AM-5PM PST)
- Phone (UK): +44-20-3885-0830 (Mon-Fri 9AM-5PM GMT)
- Phone (EU): +49-32-221094692 (Mon-Fri 9AM-5PM CET)
- Phone (Japan): +81-50-5840-2601 (Mon-Fri 9AM-5PM JST)