Plexgear Wireless Controller X2

Power on/off

Move the switch on the back of the controller to "On" to turn it on. The LED indicators light up. Move the switch to "Off" to turn off the controller.

Note: The controller enters sleep mode after 5 minutes of inactivity and the LEDs turn off. Press the [Home Button] to wake it up again.

Connecting to a PC (wireless)

Connect the included USB-A nano receiver to a free USB port on your PC or PS3. The controller is automatically installed, and the drivers show as “Xbox 360 controller for Windows” on your PC.

Charging the controller

The LED indicators located below the joysticks on the front of the controller rapidly flash to indicate that the built-in battery is low and needs to be charged.

Connect the included USB-C cable to the controller's USB port and a USB charger or computer. The LED indicators below the joysticks flash when the controller is charging and turn off when it has been fully charged.

Note: The controller has to be on during charging.

Controller modes

This controller supports XInput mode and DirectInput mode.

XInput: This is the default mode. It is designed by Microsoft for their Xbox controllers and is compatible with most platforms on PC.

DirectInput: This mode mimics earlier types of controllers for systems such as Nintendo 64 and Nintendo Entertainment System (NES). DirectInput mode also has two sub-settings: analog and digital.

• Analog: Features joystick functions similar to the N64 controller.
• Digital: Features directional button functions similar to the NES controller.

Change controller mode

Press and hold the [Home Button] on the middle of the controller for 5 seconds to switch between DirectInput and XInput mode. Your computer confirms the mode change by playing the USB device connected chime sound.

In DirectInput mode, you can switch between digital and analog by pressing the [Home Button]. The LED indicators (from left to right) show the current mode:

• Digital mode: The first indicator lights up.
• Analog mode: The first and second LED indicators light up.

To return to XInput mode, press and hold the [Home Button] for 5 seconds.

Turbo mode

Turbo is used to send a command automatically and repeatedly while holding down a button. Turbo can be enabled for multiple buttons at the same time.

Note: Turbo mode is compatible with buttons: Y, X, B, A, L1, L2, R1, and R2. Turbo mode is not compatible with: Select, Start, Clear, Home, the analog stick directions, or pad buttons.

To enable turbo mode for a button, press and hold the Turbo button while pressing the button you want to activate turbo mode for. Release the buttons to confirm.

To turn off turbo mode on a button, press and hold the Clear button while pressing the button you want to turn off turbo for.

Simplified EU Declaration of Conformity

Kjell & Company hereby declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. Full text of the EU declaration of conformity is available at www.kjell.com/61888.

Recommended power adapter

To ensure optimal and safe performance, use a CE-certified adapter with these specifications:

• Minimum charging power: 0.1 Watts
• Maximum charging power: 3 Watts (for full speed)

Only use adapters meeting these specifications to avoid performance issues or safety risks.

Symbol Description

CE: This product carries the CE mark in compliance with the provisions of the EU Radio Equipment Directive 2014/53/EU and ROHS (2015/863/EU that updated 2011/65/EU).

WEEE: Waste Electrical and Electronic Equipment. This symbol indicates that the product should not be disposed of with household waste within the EU. To protect the environment and human health from potential risks associated with improper disposal, the product should be recycled. Please take the product to an approved e-waste collection point or contact the retailer to ensure responsible handling and recycling.