Razor Power A5 Brake Fender Replacement Procedures

Required Tools (Not included)

• A. Phillips screwdriver
• B. Blade or knife
• C. 3 mm Allen wrench
• D. 5 mm Allen wrench
• E. Small flat screwdriver

WARNING

Turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures.

CAUTION

To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Replacement Steps

Step 1: Remove Controller Cover

Using a Phillips screwdriver, remove four (4) screws from the controller cover located under the deck.

[Image description: Four screws are visible on the controller cover under the scooter deck.]

Step 2: Disconnect Motor Connectors

Locate and disconnect two (2) motor connectors from the controller.

[Image description: Two electrical connectors are being unplugged from the scooter's controller.]

Step 3: Disconnect Brake Cable

Disconnect the brake cable from the controller.

[Image description: A brake cable connector is being detached from the controller.]

Step 4: Cut Grip Tape

Using a blade or knife, cut the grip tape as shown in the picture. Peel the grip tape to the side.

[Image description: A knife is cutting grip tape on the scooter deck, and the tape is being peeled back.]

Step 5: Remove Brake Fender Screws

Using a 3 mm Allen wrench, remove two (2) screws from the brake fender.

[Image description: A 3 mm Allen wrench is used to remove screws securing the brake fender.]

Step 6: Remove Wheel Bolts

Using a 5 mm Allen wrench, remove the bolts that hold the wheel in place.

[Image description: A 5 mm Allen wrench is used to loosen bolts holding the rear wheel.]

Step 7: Remove Grommet

Using a small flat screwdriver, remove the grommet at the back from inside the controller compartment.

[Image description: A small flat screwdriver is used to remove a rubber grommet from the controller compartment.]

Step 8: Remove Rear Wheel and Fender

Once the grommet is removed, slide the rear wheel and fender off the unit. Be careful not to pinch the wires.

[Image description: The rear wheel and fender assembly are being carefully slid off the scooter, with attention to avoiding wire pinching.]

Step 9: Reverse Steps

Reverse the steps to reassemble the scooter.

ATTENTION: Charge battery 10 hours before using.

Need Help?

Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.