About This Document
This document provides essential technical instructions for the Centrometal CUPREG-Touch / 100°C boiler controller. It is designed for installation and use with various Centrometal hot water boilers, including the EKO-CUP S3, EKO-CUP SU3, EKO-CUP V3, and EKO-CUP SV3 2500 models. The controller facilitates the management of oil/gas boilers, heating systems, and domestic hot water (DHW) preparation, with a maximum operating temperature of 100°C.
Please read these instructions carefully before installation and operation. For detailed information on specific components, installation procedures, and operational symbols, refer to the relevant sections within this manual.
Key Features and Components
- Boiler control for oil/gas systems
- Heating system and DHW preparation management
- Supports single-stage, two-stage, or modulation burners
- Includes touchscreen interface with bicolour LED
- Various sensors included: boiler sensor, flue gas sensor, outdoor sensor
- Additional equipment options available, such as Wi-Fi box and GSM alarm module
Important Safety Information
WARNING: All electrical work must be performed by a certified professional in accordance with valid national and European standards. The first start-up must be done by an authorized person; otherwise, the product warranty is not valid. Ensure the boiler is not operated in flammable or explosive environments, and always switch off electric energy before performing any work on the boiler.
Centrometal
Centrometal d.o.o. is a manufacturer specializing in heating technique solutions. For more information about their products and services, please visit their official website.
Visit Centrometal: www.centrometal.hr
Centrometal | TEHNIKA GRIJANJA
