Vibe Pulse LED Speaker Operation Manual
Model: FB-CHBS-MC1
Product Overview
The Vibe Pulse LED Speaker is a portable Bluetooth speaker with LED lighting. It offers a 10m operating distance and a 300mAh battery capacity, providing approximately 1.5-2 hours of running time.
Parameters
- Operating distance: 10m
- Battery capacity: 300mAh
- Basic function: USB+FM+Bluetooth +LED flashing
- TWS: 1+1 couplet function
- Running time: 1.5-2hours
- Product size: 101*50*155mm
- Speaker size: 52mm
- Output power: 3W *1
- Input voltage (V): 5V
- SNR: >=80dB
- Product material: ABS
- Standby time: 100hours
- Impedance (Ω): 4Ω
- Frequency response range: 80HZ-20KHZ
- Charging time: 2hours
- Package accessories: manual + USB charging cable
- BT ID: D059694
- FCC ID: 2AANZCHBS
Charging the Speaker
The speaker comes with a built-in rechargeable lithium-ion battery. For first-time use, it is recommended to fully charge the battery using the supplied USB cable.
- Connect the USB cable to a computer USB port and the DC 5V plug to the charging jack of the speaker.
- The red LED light will illuminate while the speaker is charging.
- A full charge takes approximately 2 hours. Disconnect the speaker once the battery is fully charged.
Pairing the Speaker
- Ensure the speaker is turned off. If not, turn it off before pairing.
- Turn on the speaker. The LED will flash blue, indicating it is in pairing mode.
- Place the speaker and the Bluetooth device within the operating distance (recommended: within 3 feet).
- Ensure Bluetooth is enabled on your phone or music device. Refer to the manufacturer's instructions for enabling Bluetooth on your device.
- On your device, select the speaker "CLIP 5+RGB" from the list of available Bluetooth devices.
- If pairing is unsuccessful, turn off the speaker and repeat the pairing steps. Once paired, the speaker will remember the device and automatically connect when Bluetooth is activated and in range.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC Instructions for a Class B Digital Device or Peripheral:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Manufacturer Information
DGL Group, Ltd.
195 Raritan Center Parkway, Edison, NJ 08837
Website: www.dglusa.com
