ROCCAT Kone Pro Air Quick Start Guide

Package Contains

The package includes:

• Kone Pro Air Gaming Mouse
• Phantom Flex™ USB-C Charging Cable
• Wireless Dongle

Default Button Assignment (No Driver Installed)

The mouse has the following default button assignments:

Quick Start Guide

1. Connect the Dongle: Plug the wireless dongle into any free USB port on your PC or laptop. Alternatively, enable Bluetooth®.
2. Select Connection Mode: Use the connection mode slider underneath the mouse. Select 2.4GHz mode to connect via the dongle, or Bluetooth® mode to connect via Bluetooth®.
3. Pairing Mode: Hold down the profile button for 3 seconds to enable pairing mode. If connecting via dongle, the mouse pairs automatically. For Bluetooth®, pair manually via your device's Bluetooth® settings.
4. Download Software: Navigate to www.roccat.org/roccat-swarm and download the latest version of Swarm.
5. Complete Installation: Install Swarm to access all software features and setup options.

Driverless Setup

You can configure the mouse without installing software:

• Config Mode: Press the profile button and the left mouse button simultaneously for three seconds. The mouse LEDs will blink with the active profile's color. To exit config mode, repeat this action.
• DPI Adjustment: While in config mode, use the scroll wheel (scroll up/down) to change DPI levels. The LEDs will indicate the selected DPI preset with a specific color (400 DPI - red, 800 DPI - green, 1200 DPI - blue, 1600 DPI - cyan, 3200 DPI - pink).
• Polling Rate Adjustment: Press the forward or backward side button to change the polling rate. The right mouse button will blink to indicate the selected rate (125Hz - blue, 250Hz - green, 500Hz - yellow, 1000Hz - white).
• Lift-off Distance: Click the mouse wheel to switch between 1mm and 2mm lift-off distance. The left mouse button will blink to indicate the selection (1mm - red, 2mm - green).
• LED Brightness: While holding the left mouse button, press the forward or backward side button to adjust LED brightness in 10% increments.
• RGB Modes: While holding the right mouse button, press the forward or backward side button to cycle through RGB modes (Static, Wave, Heartbeat, Breathing, Blinking).
• LED Color Change: While holding the left or right mouse buttons and scrolling the wheel up or down, you can change the LED color from 16 presets. Holding both buttons simultaneously changes both at once.

Technical Facts

Tech Specs Kone Pro Air

• ROCCAT® Owl-Eye 19K dpi optical sensor (based on PixArt PMW3370)
• 400 IPS (10.2m/s) maximum speed
• 40g maximum acceleration
• Default DPI steps: 400, 800 (default), 1200, 1600, 3200
• 2.4GHz frequency
• Bluetooth® mode
• 450 mAh battery, 100h+ battery life without RGB
• ROCCAT Phantom Flex™ USB-C charging cable
• 1000Hz polling rate
• Lift-off distance: 1mm, 2mm and surface calibration
• ARM32 MO+ MCU
• ROCCAT Titan Switch Optical, 100 million click life-cycle
• 75g weight

System Requirements

• Windows® 7, 8 and 10 (software support)
• USB 2.0 (or higher)
• Internet connection (for driver software)

Assistance

For technical assistance, contact ROCCAT support via email at support@roccat.org or visit www.roccat.org/support.

Join the Community

Become a ROCCAT member and register your product at: www.roccat.org/support/register-your-product

Service & support: Easy access to customer support.

Authenticity check: Make sure you own an original.

Exclusive deals: Opt-in for special offers and downloads.

Please use your product's serial number (located on the bottom label).

Disposal Information

The crossed-out wheelie-bin symbol indicates that this product must not be disposed of with unsorted household waste. Electrical devices may contain harmful substances that can damage the environment or health if not disposed of correctly, so they must be disposed of separately. As an end user, you are legally obligated to return used electrical equipment to an official recycling point. For information about local recycling points, contact your local authority, civic amenity site, or the business where you purchased this product. By disposing of electrical products at an official recycling point, you contribute to proper recycling and environmental protection. When purchasing a new product, the retailer may allow you to hand in old products for free disposal, provided the returned product is of a similar type and has the same functions as the product you are purchasing. Small used electrical and electronic equipment (no external dimensions exceeding 25 cm) can be handed in for free and without obligation to purchase a similar product at electrical and electronic retail outlets with sales areas larger than 400m², or at nearby recycling points designated by the retail outlet. Wherever possible, remove any batteries before disposing of the device. Unauthorized disposal of devices, batteries, or accumulators by the user is subject to penalties under applicable law.

Technical Support

For technical problems with this product, please contact our support team. The quickest way to reach them is via our website: www.roccat.org/support. Please keep this information for later reference.

FCC CAUTION

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Mouse FCC ID: XGB-K1PA, Dongle FCC ID: XGB-K1PA-D

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

GENERAL SAFETY GUIDELINES AND INTENDED USE

1. Do not open or modify the product.
2. Not approved changes or modifications may void the operation authority and/or warranty.
3. In case of trouble or doubt, contact us immediately.
4. Keep the product away from fire/water/humidity/temperature extremes.
5. Only use as intended with a compliant PC and connector part.
6. Improper or incorrect use of the product or use of the product for purposes not recommended by the manufacturer void the liability and/or warranty.
7. Don't look into the light beam on bottom of the mouse.

BATTERY SAFETY GUIDELINES

1. Improperly treated rechargeable batteries may catch fire or cause chemical damages and injuries.
2. Do not disassemble or modify the battery in any way.
3. If battery is damaged or appears abnormal, stop using it.
4. Do not short-circuit the battery.
5. Do not leave the battery discharged or unused for extended time periods.
6. If battery is replaceable by design, do not apply higher forces which may damage the battery.
7. Only use original equipment and cables for charging.

RF RADIATION EXPOSURE & HAZARD STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Industry Canada Compliance

This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device.

EXPOSITION AUX RADIATIONS RF & MENTION DE DANGER: The product complies with Canada portable RF exposure limits set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

Harmful Substances Information

0: Indicates that the content of the toxic and harmful substance in all homogeneous materials of this component is below the limit requirement stipulated in GB/T 26572.

X: Indicates that the content of the toxic and harmful substance in at least one homogeneous material of this component exceeds the limit requirement stipulated in GB/T 26572.

Company Information

VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR, WHITE PLAINS NY 10601, USA

© 2021 Voyetra Turtle Beach, Inc. All rights reserved. Any product names mentioned in this manual may be trademarks or registered trademarks and are the property of their respective owners. Information contained herein is subject to change without notice. Voyetra Turtle Beach, Inc. shall not be liable for any errors that may appear in this manual. This publication or parts of it may not be reproduced without the express consent of the publisher.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

BSMI Limited Use Substance Declaration Table inquiry, please visit http://bsmi.roccat.org/229

This device is a Class B device. It is intended for use in a residential environment, but may cause radio or television reception interference if used in close proximity to such devices. Please handle the device correctly according to the instruction manual. VCCI - B