IKEA Cover Panel Assembly Instructions
Tools and Materials
The following tools and materials are typically required for assembly:
- Screwdriver (cross-head) ?
- Screwdriver (flat-head) ?
- Pencil ✏️
- Knife ?
- Measuring tape ?
- Tape ?
- Saw ? (indicated with a prohibition symbol ❌, suggesting it is not to be used for the panel itself)
- Water tap symbol ? (contextual, likely indicating kitchen environment)
- Fasteners: 4x Screws (Part #117494) ?
Preparation and Overview
This guide outlines the steps for assembling and attaching a cover panel to an IKEA cabinet system. The process involves precise measurements and secure fastening.
Initial visual cues suggest consulting IKEA for guidance and preparing the workspace. Specific preparation steps may involve marking and taping edges of the cover panel, referencing internal step markers like '4' and '7'.
Assembly Steps
- Step 1: Measure and Mark Panel Edge.
Measure a specific length 'X cm (X/X")' on the edge of the cover panel and mark it.
- Step 2-5: Prepare Panel Edge.
Apply tape along the marked edge of the panel. Use a knife to carefully cut along the taped line, ensuring a clean edge.
- Step 6: Attach Panel to Cabinet.
Position the prepared cover panel against the cabinet unit. Ensure correct alignment [✔️] and avoid incorrect placement [❌].
- Step 7: Mount Cabinet to Wall.
Secure the cabinet unit to the wall. This involves using appropriate fasteners and ensuring the cabinet is stable and level.
- Step 8: Install Mounting Hardware.
Attach any necessary mounting hardware or brackets to the cabinet unit as indicated in the diagrams.
- Step 9: Secure Cover Panel.
Fasten the cover panel to the cabinet unit using four screws (Part #117494).
- Final Check.
Review the completed assembly against the instructions.
