Broadcom BCM94912REF1D Professional Installation Manual

Product Note

Note: This AP approval is to demonstrate AFC compliance for equivalent products. The AP is not for re-sale to end users.

The general public is prohibited from operating the device. Operation of the access point must be performed by the installer. Operation of the access point is limited to testing purposes only.

Regulatory Statements

USA-Federal Communications Commission (FCC)

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

INFORMATION TO USER:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver.
Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Caution: Exposure to Radio Frequency Radiation.

To comply with FCC RF exposure compliance requirements, for mobile configurations, a separation distance of at least 24 cm must be maintained between the antenna of this device and all persons.

This device must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC regulations restrict the operation of this device to indoor use only.

The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet in the 5.925-6.425 GHz band.

Transmitter Operation Restrictions

Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.

	FCC EMI Test Report for Broadcom BCM94360HMB Wi-Fi Bluetooth Card This document details the FCC Electromagnetic Interference (EMI) test results for the Broadcom BCM94360HMB 802.11abgn/11ac WLAN + Bluetooth PCI-E Mini Card, conducted by SPORTON International Inc. It covers radiated emission tests according to FCC Part 15 Subpart B, Class B standards.
	Broadcom Bluetooth Module Variants: BCM20732S, BCM20736S, BCM20737S Similarity Letter Letter of Similarity from Broadcom Corporation confirming that the BCM20732S, BCM20736S, and BCM20737S Bluetooth modules are variants of an approved product, detailing their differences and similarities.
	Broadcom Emulex Host Bus Adapters Installation Guide Release 14.4 This installation guide (Release 14.4) from Broadcom provides detailed instructions for setting up Emulex Host Bus Adapters (HBAs), including models LPe38100, LPe37100, LPe36000, LPe35000, LPe32000, and LPe31000 series. It covers installation, compatibility, major features, specifications, and regulatory information.
	BCM4360KMLG Datasheet: Broadcom WiFi 802.11ac RF Transceiver IC Technical specifications and details for the Broadcom BCM4360KMLG, a SINGLE CHIP 3X3 11 AC WiFi 802.11ac RF Transceiver IC operating at 5GHz, including part number, manufacturer, stock status, and related components.
	Broadcom Zero Trust Architecture (ZTA) Essentials: Cybersecurity Explained Explore Broadcom's Zero Trust Architecture (ZTA) essentials, detailing its core principles, five key pillars, evaluation attributes, implementation steps, and the enabling technologies that secure modern distributed environments.
	Brocade SANnav Management Portal Installation and Migration Guide This comprehensive guide provides detailed instructions for installing and migrating the Brocade SANnav Management Portal. It covers system requirements, installation prerequisites, deployment options (including vCenter and ovftool), firewall configurations, and various management scripts.
	Broadcom CVPM02, CVPM05, CVFM04 User Guide: Installation and Management Comprehensive user guide for Broadcom CVPM02, CVPM05 Power Modules and CVFM04 Cache Module. Learn about installation, configuration, monitoring, and specifications for MegaRAID cache backup solutions.
	Broadcom Emulex Fibre Channel Host Bus Adapters Installation Guide Comprehensive installation guide for Broadcom Emulex Fibre Channel Host Bus Adapters (HBAs), covering HBA identification, bracket changes, firmware settings, installation, media attachment, power application, and LED status interpretation. Release 12.8.