Electric Scooter User Manual

About the Manual

Congratulations on your purchase of the E-scooter.

For your driving safety, please read this user manual carefully before using and ensure you are able to ride the scooter under correct guidance. Learning all the safety warnings and tips listed in this manual will be helpful for you to better control the scooter.

Should you have any inquiries, please contact the supplier immediately.

Tips:

• Children below 14 years old shall be accompanied by an adult.
• People without experience, poor physical coordination, or limited acceptance ability should learn to ride with accompaniment. Please read this manual carefully before riding the electric scooter to ensure you have correct guidance.
• Children are prohibited from cleaning and maintenance of the product without parental accompaniment.

⚠ Please turn off the power after using the scooter to prevent it from starting due to accidental touching of the accelerator.

WARNING! Improper use of the scooter and/or failure to read this user manual may lead to serious bodily injury. The seller will take no responsibility for any injuries caused by improper use without following the manual.

Content Overview

• Packing list: Page 2
• Product Introduction: Pages 3-4
• Product assembly: Pages 5-7
• How to ride: Pages 8-9
• Safety notes: Pages 10-13
• Battery instructions: Pages 14-15
• Parameter: Page 16
• Maintenance: Page 17
• Warranty card: Page 18

Packing List

1. Product

• Electric scooter * 1

2. Accessories

• Charger * 1
• Wrench * 1 (T25)
• User Manual * 1

If anything is missed, please contact the dealer in time!

Product Introduction

Instructions of buttons

1. Power Switch: Long press the power button to turn on/off.
2. Function Button:
   • A: Short press function button: Cycle to switch gears.
     • Beginner mode: NO gear indicator.
     • Normal mode: Gear indicator shows white.
     • Sports mode: Gear indicator shows red.
   • B: Shortly press the function key twice to turn on/off the headlights, and the taillights will turn on or off synchronously.
3. Accelerator: Press the acceleration button to start and accelerate.
4. Brake: Hold the brake handlebar to brake.
5. Cruise mode: Keep the current speed (≥6KM/h) for 6 seconds to enter cruise mode. Exit cruise mode by pressing the accelerator again or the brake.

Note: When the brake is active, pressing the throttle button to accelerate is invalid!

Product Assembly

1. How to Assemble

2. How to Fold

3. Battery Removal and Installation

Remove the battery:

Install the battery:

How to Ride

1. Wear helmets and other protective equipment before riding.
2. Long-press the power button to turn on the scooter. Stand on the pedal with one foot, press the accelerator, and push off with the other foot from the ground.
3. When the electric scooter is sliding, place your other foot on the pedal and keep both feet stable.
4. Continuously press the throttle to speed up. Turn the handle to adjust the direction.
5. Hold the brake grip firmly to slow down and stop.

   Note:

   • Riding in rain or snow will extend the braking distance; pay attention to slow down.
   • The rear brake is for normal driving. Use front and rear brakes together for emergency braking. Do not use only the front brake for emergency braking at high speed, as it can cause a rollover.

6. When the scooter stops or runs at a slow speed, you can get off.
7. Please do not ride at high speed before you are familiar with the performance of the scooter to avoid accidents.

Safety Notes

• 1. Please abide by traffic laws when using electric scooters. Forbidden to ride it into motor lanes. [Traffic signal symbol, forbidden symbol]

• 2. Do not park electric scooters in the building's lobby, evacuation corridor, or safety exit. [Parking forbidden symbol]

• 3. DO NOT ride after drinking or taking medicine. [Alcohol/pill forbidden symbol]

• 4. Forbidden to ride with overweight (maximum load: 100Kg). [Weight symbol >100kg]

• 5. Forbidden to ride on the road with heavy water, which is easy to cause danger. [Rain/water forbidden symbol]

• 6. Pregnant women and users younger than 16 years old or older than 60 years old are not allowed to ride. [Age symbols <16, >60]

• 7. Forbidden to ride electric scooters up and down steps or jumping obstacles. [Scooter on steps forbidden symbol]

• 8. Forbidden to leave the handlebar with one hand or both hands at the same time when riding. [Hand off handlebar forbidden symbol]

• 9. Forbidden for multiple people or carrying children to ride an scooter at the same time. [Multiple people/child forbidden symbol]

• 10. Forbidden to modify the battery of an electric scooter privately. Modification of the battery is dangerous, and improper operation may cause the battery to explode or fire. [Battery explosion symbol]

• 11. Forbidden to modify electric scooters privately. Private modification may cause an unstable electronic system and cause danger when riding. [Hammer/wrench forbidden symbol]

Battery Instructions

This section covers how consumers charge and maintain the battery for a long lifespan and optimal performance. Please refer to this manual and follow instructions.

6.1 Battery Parameters

Recommended tire pressure: 220Kpa~240Kpa

12. Before riding an electric scooter, please carefully check its condition to ensure there are no signs of looseness or damage on any part.

13. Before using the electric scooter, check whether the power circuit, front and rear lights, reflectors, front and rear brakes are normal. Stop using it and repair it in time if there is an abnormality.

6.2 Battery Warnings

• 1. The battery must be charged and used within the specified temperature range for stable and efficient operation.
• 2. Please remove the charger when installing the battery to prevent any danger.
• 3. Never dissolve, impale, or allow metal objects to contact the battery pin electrode, as this may damage the battery.
• 4. Do not disassemble or pierce the battery pack casing to avoid short circuits caused by metal objects contacting battery contacts, which could lead to battery damage or personal injury.
• 5. If water enters the battery circuit, it may cause fire or explosion. Stop using the battery immediately and contact after-sales service.
• 6. Only use the original adapter provided. Using other chargers may lead to unexpected consequences.
• 7. If the battery is broken, smells bad, or feels hot, stop using it and keep it away from other items.
• 8. Storing the battery at 100% charge helps prolong its lifespan.
• 9. Do not store the battery below -20°C or above 50°C.
• 10. If the battery is not used for more than 30 days, charge it to at least 80% capacity. Charge it to 100% every 90 days to protect its function.
• 11. Charging the battery properly after each drive significantly prolongs its lifespan. At room temperature, the battery offers higher range and performance. Performance degrades below 0°C; the range may be half or less at -10°C compared to room temperature.
• 12. Do not charge or park electric scooters in residential buildings. Keep away from combustibles when charging, and avoid prolonged charging times.
• 13. Improper disposal of used batteries can seriously pollute the environment. Please abide by local regulations when disposing of batteries.

Tips:

• 1. If the internal temperature of the battery exceeds 50°C, it enters a protected state and cannot be charged.
• 2. After a full charge, the electric scooter's stored power depletes after about 90-120 days of standby. If not recharged in time, excessive discharge can cause unrecoverable battery damage, which is beyond warranty.

6.3 Charging Steps

1. Open the dust cover on the battery charging stand.
2. Connect the DC plug of the charger to the battery charging socket.
3. Connect the AC plug of the charger to the AC power socket (100-240V, 50/60Hz). The charger's red light will turn on, indicating charging. The indicator turns green when charging is complete.

Tip: When the battery is charged separately, the charging status can be viewed on the battery's charging indicator. It displays red when charging and green when fully charged.

Note: Only use the original electric scooter charger for charging. Do not use other models of power chargers to avoid danger caused by voltage mismatch.

Parameter

Maintenance

8.1 Cleaning and Storage of Electric Scooter

If there are stains on the surface of the electric scooter, wipe with a damp soft cloth. If the plastic parts of the body are scratched, use sandpaper or other abrasive materials for polishing.

Tips:

• 1. It is forbidden to use alcohol, gasoline, kerosene, or other corrosive and volatile chemical solvents for cleaning, as they will seriously damage the appearance and internal structure of the scooter.
• 2. It is forbidden to use high-pressure water guns to spray and flush. When cleaning the electric scooter, ensure the scooter is turned off, the charger is unplugged, and the dust cover of the charging port is fastened. Otherwise, it may cause electric shock or major failure due to the scooter being flooded.
• 3. Electric scooters should be stored in a cool and dry indoor place. Avoid storing outdoors for extended periods. Sun exposure, overheating, and cold outdoor environments will accelerate the aging of the electric scooter and tires, and reduce the lifespan of the electric scooter and its lithium battery.

8.2 Maintenance of Electric Scooter Tires

The tires of this product are pneumatic. When the tire tread sinks 20%-30%, it needs to be inflated. The recommended inflated tire pressure is 220 Kpa-240 Kpa. The tires need to be inflated at least once every 2-3 months. Regular inspection of tire inflation can reduce the risk of punctures and extend the life of the tire.

Warranty Card

9.1 Product Inspection

The product has passed the inspection of the quality control department and is allowed to be sold. Please keep the warranty card and purchase invoice properly, and present them when requesting repairs.

Effective date: [Date]

Quality inspection pass seal: [Seal]

9.2. Warranty Card Details

Please keep the warranty card and purchase invoice as proof of after-sales service. This card must be provided during warranty service. If this card is not provided or is altered privately, the company reserves the right to refuse warranty treatment!