Automotive OEM integration | CRUX Interfacing Solutions
Instruction Manual for CRUX models including: SWRVW-52B Wiring Interface, SWRVW-52B, Wiring Interface, Interface
CRUX SWRVW-52 Wiring Interface Connect a new car stereo and retain the factory amp and steering wheel audio controls in select 2002-up Volkswagen models at Crutchfield
File Info : application/pdf, 2 Pages, 4.17MB
DocumentDocumentINTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION PRODUCT FEATURES: SWRVW-52B Radio Replacement with Steering Wheel Control and Factory Backup Camera Retention for Select Volkswagen Vehicles NOTES: PARTS INCLUDED: SWC Cables INSTALLATION DIAGRAM: +12V Constant +12V ACC Ground Illumina on (+) Vehicle Speed Sense Reverse Gear Signal Right Front (+) Right Front (-) Le Front (+) Le Front (-) Right Rear (+) Right Rear (-) Le Rear (+) Le Rear (-) Backup Camera Input Yellow Red Black Orange Purple/White Red/White Gray Gray/Black White White/Black Purple Purple/Black Green Green/Black Yellow RCA TO FACTORY HARNESS OPEN CLOSE SEEK SEEK AFTERMARKET MENU RADIO RADIO MEDIA AUDIO VOLUME TROUBLESHOOTING LED LIGHT Solid blue LED MODULE FEEDBACK CAN recognized Flashing blue CAN not recognized Solid red Red off Module providing 12V ACC 12V ACC OFF Backup camera input 4-Pin Connector ON 1 2 3 mini USB Not Used 3.5MM SWC CABLES (Option A or B) Use the proper 3.5MM to 4-Pin cable for your radio. Plug in the selected 3.5MM SWC cable to the 4-pin port on the module. See "DIP SWITCH SETTINGS" section. 12-Pin Connector Option B: BLUE / YELLOW FOR JVC & KENWOOD Option A: To aftermarket radio SWC wire or 3.5mm port Cap or insulate if not being used 1 of 2 Crux Interfacing Solutions · 21541 Nordhoff St., Unit C, Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.071922 INTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION SWRVW-52B Radio Replacement with Steering Wheel Control and Factory Backup Camera Retention for Select Volkswagen Vehicles SETTING THE AFTERMARKET RADIO BRAND corresponding radio listed below. RADIO BRAND: DIP#: 1 2 3 Atoto, Dual, Fahrenheit, Jensen OFF ON ON Pioneer, Power Acoustik, Soundstream OFF ON ON OFF ON ON Alpine OFF OFF OFF Clarion ON ON OFF Kenwood ON ON ON JVC ON OFF ON Boss, Old Sony ON OFF OFF New Sony OFF ON OFF SWC MODULE DIP SWITCH ON 1 2 3 NOTE: check the aftermarket radio's manual to see if the SWC buttons need to be programmed. 4-PIN SWC CABLE OPTION A is used for ALPINE, CLARION. For JVC and KENWOOD use the Blue/Yellow wire. OPTION B is used for ATOTO, BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK, NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used. SWC wires as follows: RED to SWC Key 1 WHITE to SWC Key 2 SHIELD to SWC Ground Note that there are some radios that only have SWC1 and SWC2, in this case "shield" does not need to be connected. VEHICLE APPLICATIONS: VOLKSWAGEN 2016 2018 2015 2018 2017 2018 2015 2018 2015 2017 Beetle Golf / GTI Golf Alltrack Golf R Golf Sportwagen 2016 2018 Passat 2016 2017 Tiguan 2017 Beetle Radio 2 of 2 Crux Interfacing Solutions · 21541 Nordhoff St., Unit C, Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.071922