Installation Steps
Step 1
Using a Phillips screwdriver, remove the four (4) screws that hold the seat fairing onto the frame.
[Image Description: Four screws securing the seat fairing to the scooter frame are circled.]
Step 2
Lift the seat cover, being careful not to pull the wires from the power switch, and set the seat cover aside.
[Image Description: The seat cover is lifted, revealing internal wiring connected to the power switch.]
Step 3
Cut the zip tie that holds the wires onto the frame. Locate and disconnect the charger port from the controller.
[Image Description: A hand is shown cutting a zip tie securing wires to the frame, and then disconnecting a wire connector.]
Step 4
Disconnect the black wire from the charger port that connects to the power switch.
[Image Description: A black wire connector attached to the power switch is shown being disconnected.]
Step 5
Using a flathead screwdriver, remove the plastic glue from the back of the charger port. Using long nose needle pliers, remove the ring at the back of the charger port and push it out from the seat fairing.
[Image Description: A flathead screwdriver is used to remove glue, and needle-nose pliers are used to remove a retaining ring from the charger port assembly.]
Step 6
Using a small pointy object, depress the tabs from the prongs and remove the prongs from the white connector.
[Image Description: A small pointed object is used to release tabs on a white electrical connector to disconnect wires.]
Step 7
Reverse the steps to install the new charger port.
ATTENTION: Charge battery 12 hours before using.
