Installation Guide for Razor models including: MX125, MX125 Dirt Rocket Rear Wheel, Dirt Rocket Rear Wheel, Rocket Rear Wheel, Rear Wheel, Wheel
Dirt Rocket - Support - Razor
REAR WHEEL REPLACEMENT. INSTALLATION INSTRUCTIONS. PART # W15118260048 ... NOTE: Make sure to inflate tire to the correct PSI after installing wheel.
File Info : application/pdf, 2 Pages, 1,000.59KB
DocumentDocumentDIRT ROCKETTM MX125 REAR WHEEL REPLACEMENT INSTALLATION INSTRUCTIONS PART # W15118260048 Required Tools: (Not included) A. Phillips screwdriver B. 8 mm Allen wrenches (2) C. 10 mm Allen wrench D. 15 mm Allen wrenches (2) WARNING CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage. Step 1 Using a Phillips screwdriver, remove the five (5) screws on the chain guard. The locations of the screws are circled in the image below. Remove chain guard and set aside. Step 2 With a 10 mm wrench, loosen the brake cable anchor bolt (circled in the image below) and disconnect the cable. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 1 Step 3 With two (2) 8 mm wrenches remove the cable guide bracket from the frame and brake plate. Step 4 With two (2) 15 mm wrenches loosen the axle lock nuts. Step 5 Push the chain tensioner down to loosen the chain and remove wheel. Step 6 Reverse the steps to install new rear wheel. NOTE: Make sure to inflate tire to the correct PSI after installing wheel. ATTENTION: Charge battery 12 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 2