AOTOWO
Installation Guide for CALLIERT models including: 20-25 JEEP WRANGLER JT, 20-25 Jeep Wrangler JT Front Inner Fenders, 20-25, Jeep Wrangler JT Front Inner Fenders, Wrangler JT Front Inner Fenders, JT Front Inner Fenders, Front Inner Fenders, Inner Fenders, Fenders
File Info : application/pdf, 8 Pages, 3.47MB
DocumentDocument20-25 JEEP WRANGLER JT Front Inner Fenders Before installation - Read and understand all instructions, warnings, cautions, and notes contained in this installation instruction guide. Consult your vehicle owner's manual for proper installation of this product. This install may require some technical skills and knowledge of basic mechanical work. If you do not feel that you are capable of performing this install please take this product to a trained professional. concerns before installing product. E-mail: tech@calliert4x4.com CALLIERT is not responsible for any bodily injury or harm to you or your vehicle as a result of an improper install. Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper performance of these components and the safety of the vehicle. Always wear eye protection when operating power tools. Inspect all contents of this package to make sure product is not damaged and all installation hardware has been included. If parts are missing from kit, please be prepared to provide the following information: · Name of purchase location · Bar Code on side of box Visit our website at: https: www.aotowo4x4.com Front 1 2 2 1 4 4 3 3 a. ×26 M6*20 Buon Head Hex Socket Bolt b. ×26 M6*14*1 Washer d. ×1 Rivet Nut Tool e. ×2 Rivet Nut c. × 18 M6 Hex Flange Nut f. ×6 U-nut Clip ×2 6 5 1× 7× 12 34 56 Begin by unpacking all items and inspecting them for damage or missing items.Any concerns, please contact the company you purchased the inner fenders from.Hardware required. Preassemble the front inner fender liner using bolts,washers, nuts. Leave the bolts finger tight, as they will be tightened in a later step. (a*7 b*7 c*7) Hardware required. (a*1 b*1 c*1 e*1 f* 3 5 * 1 6 *1 Place the clip nut to the designated holes on the vehicle's body. Secure the lower mounting point Secure the top mounting point using the using the bolts, washers, threaded bolts, washers, threaded plate (item no.5). plate (item no.6). Connected by the Place the clip nut to the threaded plate (item no.5). clip nut. Note: It is necessary to adjust the bracket to the Note: The U-nut Clip is fastened at the proper position before tightening the screws. square hole, and the round hole is connected to the vehicle body with a screw. Install the rivet nut into the designed hole. Drilling is necessary to fit the ri.vet nut into the hole. Hardware required. (a*5 b*5 c*1) FRONT Mounting the pre-assembled liner to the body using bolts, washers and nuts. Next, attempt to tighten all the inner fender bolts that were previously hand tight. Bolt the last bolt through the factory hole. FRONT . Repeat on the opposite side.