Step 1: Remove Screws

Remove the three screws from the T100 amplifier.

[Diagram: TruAudio T100 amplifier with three screws indicated for removal.]

Step 2: Attach OEB and Rack Mount

Attach the OEB and rack mount to the T100 using two of the removed screws from the T100 and the included screw.

[Diagram: OEB bracket attached to T100 amplifier, showing screw locations and rack mount. Labels: OEB BRACKET, SCREW FROM T100, INCLUDED SCREW, T100 RACK MOUNT.]

Step 3: Attach A.1x Unit

Attach the A.1x to the two pre-installed screws on top of the OEB using the keyholes on the back of the A.1x.

[Diagram: A.1x unit being attached to the OEB using keyholes, showing pre-installed screws on OEB and A.1x KEY HOLES.]

Step 4: Finished Installation

The completed installation of the OEB and A.1x units with the T100 amplifier.

[Diagram: Final assembled setup of T100 amplifier with OEB and A.1x mounted.]