BenQ Recycle Disassemble Instruction
(Dismantled Information)
Requirements according to ANNEX VII of DIRECTIVE 2012/19/EU on waste electrical and electronic equipment (WEEE)
LCDs may contain hazardous substances like Pb and BFRs which are covered by exemptions under the RoHS directive. However, the majority is present in the printed circuit boards assembly. In order to reduce emissions as much as possible, a complete disposal of the old appliance is required. This treatment may only be performed in authorized handling plants.
Product Information
Product Name: LCD Monitor
Model No.: EX240N
A description of the BenQ EX240N monitor, showing its rear view with the "MOBIUZ" branding.
Disassembly Tools
| Tool | Picture Description |
|---|---|
| Philips Screwdriver for M3 Screw | A red-handled Philips head screwdriver. |
| Nosed Pliers | A pair of red-handled pliers with pointed jaws. |
| Diagonal Cutting Pliers | A pair of red-handled diagonal cutting pliers. |
| Slotted screwdriver | A green-handled slotted head screwdriver. |
| Six Point Sockets | A yellow-handled tool with a six-point socket head. |
| Philips Screwdriver for M2.5 Screw | A red-handled Philips head screwdriver, smaller than the M3 version. |
| Knife | A utility knife with a retractable blade. |
Disassembly Process
Disassemble Stand
The rear of the monitor is shown. A hand is shown detaching the stand from the monitor's base.
Disassemble Vesa CVR
The rear of the monitor is shown. A hand is pressing on a section of the rear cover. Another image shows the rear of the monitor with four red squares highlighting screw locations for the VESA cover.
Unscrew the indicated screws.
Disassemble RC
A hand is shown prying open the rear cover of the monitor.
Disassemble SPK Wire connector
A hand is shown disconnecting a speaker wire connector inside the monitor.
Disassemble Internal Remove All Tapes
The inside of the monitor is shown with various internal components and tapes.
Disassemble HD/PCB.
Two printed circuit boards (PCBs) are shown, connected by wires. An arrow points to these as WEEE annex II items.
Remove Panel
The monitor panel is shown after the rear cover has been removed. An arrow points to a component on the panel as a WEEE annex II item.
Disassemble ASSY Deco
A disassembled decorative plastic piece from the monitor assembly.
Disassemble ASSY MF
Internal components of the monitor are shown, including small PCBs and connectors, identified as WEEE annex II items.
Disassemble ASSY RC
The rear casing of the monitor is shown disassembled, along with various small electronic components and connectors.
Disassemble all PCB.
Two main PCBs are shown, identified as WEEE annex II items.
Disassemble Column
Components of the monitor's stand column are shown disassembled.
Disassemble BASE
Components of the monitor's base stand are shown disassembled, including screws and brackets.
Disassembly Time
Total time: 30 minutes
