User Manual for VEVOR models including: FBL760639, FBL760639, FBL760639 Commode, FBL760639, Commode
COMMODE MODEL:FBL760639 MODEL:FBL760639 COMMODE This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product. -1- WARNING: Read the manual completely to avoid harm, product damage, or warranty avoidance. Seek professional help if you encounter discomfort, pain or worsening symptoms. If necessary, use supervision in order to assemble and use this product correctly and safely. Do not exceed the weight limit. Regularly check for secure assembly and contact support if in doubt. Ensure the product's legs are even and locked before use, and discontinue usage if there are signs of wear, damage, or missing parts. The product is to be used on flat, stable surfaces. Do not disassemble if not necessary, as it might compromise the longevity of the product. Do not modify the product unless specified in the manual. Physiotherapist 1. Before first use, adjust the height and the width of the rail to your toilet. 2. Back up to the toilet with your assistive device (if available) until the back of your legs is touching the toilet. 3. Reach back for the rail, hold firmly, and slowly lower yourself into a seated position on the toilet. 4. To return to a standing position, place your hands on the rails firmly and push yourself up into a standing position. 5. Once you are standing, gradually let go of the rails, and only then, grab the handle of your assistive device (if available). IMPORTANT 1. Don't exceed the maximum weight capacity. 2. Use on stable surfaces only. 3. Regularly inspect for signs of wear, damage, or loose parts. 4. Clean regularly using a mild detergent and warm water, and rinse off any soap residue. After cleaning, dry thoroughly. 5. Before use, confirm with your healthcare provider that the product meets your specific needs. The following guidelines are not a substitute for medical advice. SAVE THESE INSTRUCTION -2- PART LIST When unpacking this product, check to make sure the parts listed below are included and carefully inspect them for any damage that may have occurred during transit. If any part is missing or damaged, do not attempt to assemble or use the product. NO PICTURE NAME QTY NO PICTURE NAME QTY Main frame 1 Leg B 1 Backrest 1 Suction cup leg A 1 Handrail tube 1 Suction cup leg B 1 Leg A 1 Bucket 1 -3- PRODUCT PAREMETERS Model Main Materials Seat Height Seat Rated Load FBL760639 Aluminum 480-570mm/18.9"-22.4" 227kg/500lbs INSTALLATION AND OPERATION INSTRUCTIONS 1. Installation Procedures 1 4 6 5 7 Install the suction cup legs A, B and legs A, B into the main frame in sequence according to the corresponding numbers.(Before use, make sure that the suction cup of legs A, B is tightly fitted to the ground) -4- 2 Press the buttons on the handrail assembly and insert them into the 8-shaped tube of the main frame until the buttons pop out. 3 Press the buttons on the backrest assembly and insert it into the vertical tube under the main frame until the buttons pops out. -5- 4 Place the bucket into the seat tube from the front of the main frame. As shown in the figure, the product assembly is completed. 2.Instruction 1 Press the button and pull out the leg to adjust the height (8 levels of height adjustment) -6- Zhongshan Bliss Medical Instrument Co., Ltd Address: 3-6F & 7F-1, No. 63,Tongxing East Road, Yumin Community Xiaolan, Zhongshan, Guangdong, 528414, CHINA UK EC REP REP YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX E-CrossStu GmbH Mainzer Landstr.69, 60329 Frankfurt am Main. -7-WPS 文字