TECNO SPARK 30C 5G User Manual
Exploded Diagram Specification
The following table lists the components of the TECNO SPARK 30C 5G:
Part Number | Component Name | Part Number | Component Name |
1 | TP+LCM | 2 | FRONT COVER |
3 | SIDEKEY FPC | 4 | FRONT CAMERA |
5 | MAIN PCBA | 6 | RECEIVER |
7 | RM CAM CON FOAM | 8 | REAR 48M CAMERA |
9 | MAIN PCB HEAT FILM | 10 | LT SENSOR MYLAR |
11 | RUBBER LT SENSOR | 12 | MIDFRAME |
13 | IR FPC | 14 | BACK FLASH LED |
15 | FINGERPRINT | 16 | SIMCARD HOLDER |
17 | SILVER SCREW | 18 | BAT COVER |
19 | DECO | 20 | PMMA DECO |
21 | LENS | 22 | BLACK SCREW |
23 | FP FIXED MYLAR | 24 | FP FPC RIGID FOAM |
25 | BATTERY | 26 | EARJACK RUBBER |
27 | USB RUBBER | 28 | MOTOR |
29 | SPEAKER | 30 | COAXIAL CABLE 1 |
31 | COAXIAL CABLE 1 | 32 | SUB BOARD |
33 | SUB PCB BTB RUBBER |
Know Your Phone
This section provides a visual guide to the key components of your TECNO SPARK 30C 5G:
Front View:
- 1. Front camera
- 2. Volume + button
- 3. Volume - button
- 4. Power button & side fingerprint sensor
Rear View:
- 5. NFC (Near Field Communication) indicator
SIM/SD Card Installation
Follow these steps for SIM/SD card installation:
- Power off your phone before proceeding.
- Refer to the provided illustration for correct SIM/SD card placement.
Installation Guidelines:
- If your phone supports dual SIM cards, install them as depicted in the illustration.
- If your phone supports a single SIM card and a single SD card, install them according to the direction indicated by the arrow in the illustration.
Charging the Phone
You can charge your TECNO SPARK 30C 5G using either a TECNO charger or by connecting it to a computer via a USB cable (included with the phone).
Important Note: To prevent damage to your phone and to ensure your warranty remains valid, use only official TECNO chargers and cables. Using third-party chargers or cables may void your warranty.
FCC Caution
Labelling Requirements:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) This device may not cause harmful interference.
- (2) This device must accept any interference received, including interference that may cause undesired operation.
Information to User:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
Information to the User (RF Exposure):
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and may radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception (which can be determined by turning the device off and on), the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for assistance.
Specific Absorption Rate (SAR) Information:
This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: KL8h (FCC ID:2ADYY-KL8H) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 0.92W/kg and when properly worn on the body is 0.79W/kg.
Body-worn Operation:
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
HIOS runs on Android™ OS. Android is a trademark of Google LLC.
Related Documents
![]() |
TECNO SPARK 30C 5G User Manual: Setup, Features, and FCC Information Comprehensive user manual for the TECNO SPARK 30C 5G smartphone, covering setup, SIM/SD card installation, charging, and FCC compliance information. Learn about your device's features and specifications. |
![]() |
TECNO SPARK 10 5G User Manual Official user manual for the TECNO SPARK 10 5G smartphone, covering component identification, SIM/SD card installation, charging, and FCC regulatory information. |
![]() |
TECNO PHANTOM V2 Fold 5G User Manual - Features, Installation, and FCC Information Comprehensive user manual for the TECNO PHANTOM V2 Fold 5G, covering device features, SIM card installation, charging instructions, and essential FCC compliance information. |
![]() |
TECNO SPARK 10 User Manual User manual for the TECNO SPARK 10 smartphone, covering phone components, SIM/SD card installation, charging, and FCC compliance information. |
![]() |
TECNO SPARK 10 Pro User Manual User manual for the TECNO SPARK 10 Pro smartphone, detailing its features, specifications, and safety information. |
![]() |
TECNO SPARK Go 1 User Manual User manual for the TECNO SPARK Go 1 smartphone, covering its features, installation, charging, and FCC compliance information. |
![]() |
TECNO SPARK 20 User Manual User manual for the TECNO SPARK 20 smartphone, covering phone layout, SIM/SD card installation, charging, and FCC compliance information. |
![]() |
TECNO SPARK 9 Pro User Manual User manual for the TECNO SPARK 9 Pro smartphone, covering phone components, SIM/SD card installation, charging, and FCC compliance information. |