CANOPY LIGHT INSTALLATION INSTRUCTIONS

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.

CANOPY MOUNTING

1. Install the mounting plate to a sturdy mounting surface. Tighten the 4 screws (See Diagram 1-a).
2. Hang the fixture on the square ring.
3. Connect the wires correctly.
4. Slide the fixture horizontally into the 4 card slots of the mounting plate.
5. Screw the safety clamp of the mounting plate on the fixture side (See Diagram 2).

Diagram 1-a Description: Illustrates the mounting plate being secured to a mounting surface with screws. A safety clamp is also visible, designed to attach to the fixture.

Diagram 1-b Description: Shows the canopy light fixture, highlighting its internal square ring and four card slots that interface with the mounting plate.

Diagram 2 Description: Depicts the safety clamp mechanism, showing it attached to the mounting plate and securing the fixture to the mounting surface.

PENDENT MOUNTING

1. Feed fixture wires through the Pendent Pipe.
2. Mount the Pendent Pipe into the top nut of the fixture.

Diagram Description: Shows fixture wires being fed through a pendent pipe, which is then mounted into the fixture's top nut.

WIRING

Universal voltage driver permits operation at 120V to 277VAC, 50 or 60 Hz, except for fixtures factory ordered with a (PC) option.

Standard Wiring:

• Connect the black fixture lead to the (+) LINE supply lead.
• Connect the white fixture lead to the (-) COMMON supply lead.
• Connect the GROUND wire from fixture to supply ground.

Diagram Description: A wiring schematic showing connections for a standard fixture: black wire to LINE, white wire to COMMON, and green wire to GROUND.

0-10V DIMMABLE WIRING

Universal voltage driver permits operation at 120V thru 277V, 50 or 60 Hz. For 0-10V Dimming, follow the wiring directions as shown in Diagram 3.

1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (-) COMMON supply lead.
3. Connect the GROUND wire from fixture to supply ground. Do NOT connect the GROUND of the dimming fixture to the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.

Diagram 3 Description: A wiring schematic for 0-10V dimmable control. It shows connections for LINE (black), COMMON (white), GROUND (green), DIM+ (purple), and DIM- (gray). A yellow wire is shown capped off.

CLEANING & MAINTENANCE

CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is Energized.

1. Clean lens & fixture with non-abrasive glass cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the LED.

TROUBLESHOOTING

1. Check that the line voltage at fixture is correct. Refer to wiring directions.
2. Is the fixture grounded properly?