AXXESS BACKUPCAM-3

Introduction

The BACKUPCAM-3 is designed to retain the factory backup camera to be viewed through the display screen on the aftermarket radio, or a stand-alone monitor.

Components

• 12-pin harness with a yellow RCA jack

Applications

Note: The vehicle must be running for the factory camera to power on.

Connections to be Made

From the 12-pin harness with a Yellow RCA jack

To the aftermarket radio:

• Connect the Yellow RCA jack to the BACKUP CAMERA input.

To the vehicle:

• Connect the female 12-pin harness with a Yellow RCA jack, to the male Gray harness removed from the Human Machine Interface module. (See Figure A)

Module Location

For Chevy Colorado and GMC Canyon:

• This module is located in the radio cavity, down low.

For all other models:

• This module is located behind the glove box. There are (2) modules behind the glove box. This module is behind the metal dashboard support. (See Figure B)

Glove Box Removal (for other models):

• Drop the glove box down by first removing the retaining cable on the right side. Then squeeze the glove box sides and gently pull down.
• Remove (6) T-15 Torx screws securing the plastic panel now exposed.

Diagram Descriptions

Installer Resources

Knowledge is Power: Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians.

Technical Support

If you are having difficulties with the installation of this product, contact our Tech Support line by phone at 1-800-253-TECH, or email at techsupport@metra-autosound.com. Before contacting support, please review the instruction booklet again to ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.