Tunturi Cardio Fit Vibration Plate V20 User Manual

Welcome to Tunturi

Thank you for purchasing this Tunturi equipment. Tunturi offers a wide range of home fitness equipment, including crosstrainers, treadmills, exercise bikes, and rowers. Tunturi equipment is suitable for the entire family, no matter what fitness level. For more information, please visit the Tunturi website: www.tunturi.com

Important Safety Instructions

This Owner's Manual is an essential part of your training equipment. Read all instructions in this manual before you start using this appliance. The following precautions must always be followed:

Safety Precautions: Environment for Use

• Do not use the vibration plate in humid or dusty environments to avoid electric shock or mechanical breakdown.
• Do not use the vibration plate when indoor temperature is over 40°C.
• Do not use the vibration plate in the open air or under direct sunlight.
• Place the vibration plate on a flat floor.

People with Health Conditions Not Suggested to Use the Vibration Plate:

It is strongly advised to consult a doctor before use, especially for patients who are under treatment or do not feel well. This includes individuals with:

• Malignant tumors.
• Pregnancy or menstrual period.
• Heart disease, osteoporosis.
• Implanted heart pacemakers or other medical electronic instruments.
• Artificial limbs.
• Sensitivity to vibration and strenuous exercise.

Notices During Operation

• Before use, remove watches, bangles, cell phones, other valuable objects, keys, knives, or other incisive objects to avoid damage or body injury.
• Do not smoke while using the vibration plate.
• Do not use the vibration plate together with other medical equipment.
• Do not use the vibration plate for medical treatment purposes.
• Do not use the vibration plate right after a meal or drink.
• During use, keep children and/or pets away from the vibration plate.
• It is forbidden to put fingers or other foreign bodies into the gap between the middle cover and base cover.
• Supervision is needed for children under 10 years and aged over 60 years during use.
• The load capability of the vibration plate is 120kg (265lbs); people over this weight are not suggested to use the vibration plate.
• This vibration plate is only limited for one-person use.

Stop Using and Unplug Power Cord Immediately Under Below Conditions:

• Water or other liquid is accidentally splashed onto the vibration plate or controller.
• Any accessory is found damaged or internal component is exposed.
• Abnormal or severe pain is felt during use.
• Power failure.
• Thundering or lightning weather.

Plug and Power Cord

• Check if the voltage complies with the one specified for the vibration plate.
• Do not retract the power plug with a wet hand to prevent electric shock.
• Hold the plug rather than the power cord to pull out the power cord.
• Turn off the power switch and remove the plug from the power supply in case of electrical failure or if not in use for a long time.
• Stop using the vibration plate if the power cord has any damage; turn off the power switch, pull the plug, and replace the power cord or contact technicians for repair.
• Do not run the mains cable underneath the equipment or carpet. Do not place any objects on the mains cable.

Name and Function of Controller

Power:

Press the button while power plug is in. LCD shows "00" "10", the machine toggles between "On mode" and "Standby mode".

Mode:

Press auto program button to start a pre-programmed profile "P1, P2, P3" quickly.

Start/Pause (▶/‖):

Press the button to start the vibration plate. In operation, press to stop working.

Speed+ (▲):

Increase speed: Manual 1-30. Press to increase speed when the machine is operating.

Speed- (▼):

Decrease speed: Manual 1-30. Press to decrease speed when the machine is operating.

Time+ (+):

Time increase: Default working time is 10 minutes, divided into 10 levels. Press to increase time (± 1 minute).

Time- (-):

Time decrease: Default working time is 10 minutes, divided into 10 levels. Press to decrease time.

Function:

Control the three major functions of the vibration plate: Oscillation, Vibration, and Oscillation/Vibration combination.

Explanation of Display Functions

Speed:

Displays current training vibration frequency setting. Range: 1 ~ 30.

Time/Program:

Shows remaining time when workout.

Storage and Maintenance: Surface Cleaning

• The rubber protective top mat and covers can be cleaned with a wet cloth containing detergent. The detergent should be removed with a cloth.
• Do not clean the vibration plate with corrosive detergent such as benzene or thinner, as it may cause fading, corrosion, or cracks on the vibration plate's shell.
• Do not splash water into the vibration plate to avoid short circuits.

Clean the Remote Controller:

As a wet cloth may cause malfunction of the controller, only a dry cloth can be used. When cleaning the remote controller, it is recommended to take out the battery first.

Storage and Maintenance:

• Make sure that the power switch is turned off and the plug is removed from the power supply.
• Clean off dust and dirt on the vibration plate and keep it clean and away from places with high temperature or high humidity.
• If the vibration plate is not in use for a long period, a dust-proof cover (to be purchased separately) should be applied to prevent dust entry.

Change of Fuse:

Turn the fuse base in the direction of the arrow (counter-clockwise), and replace the fuse with a clockwise screw back.

Troubleshooting

The Vibration Plate Cannot Be Started:

• The plug is not in place; insert the plug to resolve.
• The power switch is in Off mode; turn the power switch to ON mode.
• Thermal fuse is burnt; replace with a new fuse of the same model.

Sound Like "Phew" or "Da-da" Is Heard During Working:

This is normal operational sounds produced by the motor or from the abrasion between mechanical parts.

Operate the Controller, But the Vibration Plate No Action:

• The battery power of the remote is low; replace the battery to resolve.
• The remote control is out of the receiver's reach; make sure the space between the sender and receiver is not blocked and not over 2.5 meters.

Sudden Stop of the Unit:

Default or pre-set working time is up; restart the unit after a 10-minute interval.

Unit Does Not Respond to Commands:

Too many commands sent to the unit in a short time cannot be processed simultaneously; restart the unit, unplug the power cord for at least 5 seconds, and then start the unit to resolve.

Display Shows ER01 or ER02:

Motor power problem and unit stops to protect from damage. Restart the unit, unplug the power cord for at least 5 seconds, and then start the unit to resolve.

Warranty

Warranty Terms:

The consumer is entitled to the applicable legal rights stated in the national legislation concerning the commerce of consumer goods. This warranty does not restrict these rights. The Purchaser's Warranty is only valid if the item is used in an environment approved by Tunturi New Fitness BV for that particular equipment. The product-specific approved environment is stated in the Owner's Manual provided with your equipment.

Warranty Conditions:

The warranty conditions commence from the date of purchase. Warranty conditions may vary per country, so please consult your local dealer for the warranty conditions.

Warranty Coverage:

Under no circumstances shall Tunturi New Fitness BV or the Tunturi Distributor be liable by virtue of this warranty or otherwise for any special, indirect, secondary, or consequential damages of any nature arising out of any use or inability to use this equipment.

Warranty Limitations:

This warranty covers manufacturing defects in the fitness equipment as originally packed by Tunturi New Fitness BV. The warranty shall apply only under conditions of normal, recommended use of the product as described in the Owner's Manual and providing that Tunturi New Fitness BV's instructions for installation, maintenance, and use have been complied with. Neither Tunturi New Fitness BV's nor the Tunturi Distributors' obligations apply to defects due to reasons beyond their control. The warranty applies only to the original purchaser and is valid only in countries where Tunturi New Fitness BV has an authorized importer. The warranty does not extend to fitness equipment or components that have been modified without the consent of Tunturi New Fitness BV. Defects resulting from normal wear, misuse, abuse, corrosion, or damage incurred during loading or transportation are not covered.

The warranty does not cover sounds or noises emitted during use where these do not substantially impede the use of the equipment and where they are not caused by a fault in the equipment.

The warranty does not cover defects arising from the failure to carry periodic maintenance as outlined within the Owner's Manual for the product. Furthermore, the warranty does not cover defects arising from usage and storage within an unsuitable environment as described within the Owner's Manual which should be indoors, dry, dust and grit free and within a temperature range of +15°C to +35°C. The warranty does not cover maintenance activities, such as cleaning, lubricating, and normal part adjustments, nor installation procedures that customers can accomplish themselves, such as changing uncomplicated meters, pedals, and other similar parts not requiring any dismantling/reassembling of the fitness equipment. Warranty repairs carried out by other than authorized Tunturi representatives are not covered. Failure to follow the instructions given in the Owner's Manual will invalidate the product's warranty.

Declaration of the Manufacturer

Tunturi New Fitness BV declares that the product is in conformity with the following standards and directives: EN 957 (HC), 89/336/EEC. The product therefore carries the CE label.

04-2020

Disclaimer

© 2020 Tunturi New Fitness BV. All rights reserved.

The product and the manual are subject to change. Specifications can be changed without further notice.

Product Overview and Components

The Tunturi Cardio Fit Vibration Plate V20 is a compact home fitness device. It consists of a main base unit with a vibrating platform, and can be used with or without an attachable seat for different exercise postures. The control panel is integrated into the base unit, and a remote control is also provided for convenience.

The manual includes an exploded view diagram and a detailed parts list (pages 30-31) to assist with assembly and identification of components. For specific part numbers and assembly steps, please refer to the original PDF manual.