Calibration Instruction

If the level is dropped or you suspect inaccuracy of the level, you can re-calibrate the zero point.

1. Place the level on a flat surface, press "reset" button.

   [Image description: A hand is shown pressing the 'Reset' button on a MOTORHEAD digital level. The device's display shows '0.1'.]

2. Press "calibration" button till it appears "CAL1".

   [Image description: A hand is shown pressing the 'Calibrate' button on the MOTORHEAD digital level. The device's display shows 'CAL1'.]

3. Press "calibration" button again, it will appear "CAL2".

   [Image description: A hand is shown pressing the 'Calibrate' button on the MOTORHEAD digital level. The device's display shows 'CAL2'.]

4. Flip the level over, press "calibration" button till it beeps, now level is calibrated ready.

   [Image description: The MOTORHEAD digital level is flipped over. A hand is shown pressing the 'Calibrate' button. The device's display shows '0.1', indicating successful calibration.]