Human Touch Perfect Chair PC-350 Omni-Motion Limited

Important Safety Instructions

When using an electrical appliance, basic precautions should always be followed, including the following:

Read all instructions before using this appliance.

DANGER: To reduce the risk of electrical shock

Always unplug this product from the electrical outlet immediately after using and before cleaning or servicing.

WARNING: Risk of Electric Shock, Fire, and Injury.

• Do not put hands or fingers near the footrest mechanism on the underside of the chair while this product is running. Touching the mechanism can result in injury.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
• An appliance should never be left unattended when plugged in. Unplug from outlet when not in use, and before putting on or taking off parts.
• Close supervision is necessary when this product is used by, on, or near children, invalids, or disabled persons. Keep children away from extended foot support (or other similar parts).
• Use this product only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
• Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return this product to a service center for examination and repair.
• Do not carry this appliance by supply cord or use cord as a handle.
• Always keep the power cord away from heated surfaces.
• Never operate this product with the air openings blocked. Keep the air openings free of lint, hair, and the like.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
• To disconnect, turn all controls to the off position, then remove plug from outlet.
• Do not use this product when standing on a damp floor, or when any part of the body is in contact with plumbing or any similar ground.
• Do not use this product if noise above normal sound is heard.
• Do not stand on or in appliance. Use only while seated.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Review the assembly instructions to confirm that the appropriate critical components and accessories are being used with the furnishing.
• The product should be installed flatly and firmly on the floor.

Safety Precautions

• Comfortable clothing is recommended while using this product.
• If you feel any abnormal discomfort during the operation of this product, turn off the power immediately and do not use the product. Consult your physician.
• Do not pull on the AC cord.
• When using this product after it has been in storage, check to see that the product is operating properly prior to use.
• Always confirm that there are no obstacles behind the product and that there is sufficient space to recline.

SAVE THESE INSTRUCTIONS

Do not attempt to repair this product yourself.

• This product is designed for personal in-home use. Commercial use will void warranty.
• To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wide than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

SERVICING OF DOUBLE INSULATED PRODUCTS

In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated product, nor is a means for grounding to be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and is to be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the parts they replace. A double-insulated product is marked with the words "DOUBLE INSULATION" or "DOUBLE INSULATED." The symbol (square within a square) is also able to be marked on the product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Get Ready

Unpack the Boxes

The "Unpack the Boxes" section shows line drawings of the components: a chair frame, a headrest frame, a body pad, a head pad, a head pillow, an arm core, two arm caps, screws (labeled as 4 and 6), a 3/16-inch Allen key, and a Phillips-head screwdriver.

Attach the Backrest Frame

1. Raise the chair to an upright position. Plug in the chair and use the electric recline lever to adjust it to an upright position. Ensure the power cord lies beneath the mechanics.
2. Remove the two screws from the headrest frame using the Phillips-head screwdriver. Retain these screws for step 4.
3. Insert the headrest frame into the chair frame. With the headrest frame positioned to tilt forward, slide its ends into the open tube ends of the chair frame.
4. Replace the headrest frame screws using the Phillips-head screwdriver to secure the headrest frame to the backrest frame.
5. Install the canvas backrest support. Pull the chair canvas upward firmly, wrap the top flap around the backrest frame, align the two hook-and-loop fastener strips, and press them together. Ensure the canvas is stretched tight for proper back support.

Attach the Body Pad

1. Slide the body pad onto the lower part of the chair frame, ensuring the frame slides into the fabric pocket on the bottom side of the pad.
2. Smooth the body pad into place from the footrest toward the seat. Pull up on the backrest pad until the hook-and-loop fastener strip on its back aligns with the hook-and-loop fastener strip on the chair canvas, then press the strips firmly together.

Attach the Head Pad

1. Slide the head pad over the headrest frame, ensuring the frame slides into the fabric pocket at the bottom of the pad. Pull the head pad down as far as possible.
2. From the front of the chair, tuck the flap on the top of the body pad up into the head pad and smooth the lower part of the head pad flat. The flap is automatically secured by hook-and-loop fasteners.
3. Attach the head pillow straps to the head pad straps using hook-and-loop fasteners. Adjust the head pillow height for maximum comfort.

Attach the Arm Core and Caps

1. Attach the right-hand arm core. Remove the four screws taped to the top of the right-hand arm, place the arm core on the mounting plate, and secure it with the four screws and Allen key.
2. Attach the arm caps. Remove the three screws taped to the underside of the right-hand arm cap, place it on the armrest, and secure it with the three screws from the underside. Repeat for the left-hand arm cap.

Take a Seat

Adjust the Recline Angle

Before adjusting the recline angle, ensure there is nothing directly behind or beneath the chair. Gently push down on the electric recline lever to recline backward, or pull up on the lever to adjust the angle forward. Release the lever at the desired angle. The chair stops automatically at maximum recline or full upright position. In the full upright position, the legrest automatically folds inward for easy entry and exit. Note: Lean back against the backrest before reclining. Do not apply extra pressure on the footrest while reclining, as this may prevent it from deploying and locking properly.

When adjusting the footrest up and down, you may notice a slight bumping sensation. This is caused by the footrest locking mechanism and is perfectly normal.

Adjust the Headrest

While seated, reach up with both hands and grasp both sides of the headrest frame. Tilt the headrest forward or backward for maximum comfort. The headrest remains in this position until adjusted again.

Getting Out of the Perfect Chair

While seated, pull up gently on the electric recline lever until the backrest automatically stops in a full upright position and the footrest stops in a vertical position (the backrest stops before the footrest). Use the armrests for support when getting up from the chair.

Care and Maintenance

To keep your product working and looking its best, please follow these simple care guidelines.

WARNING:

1. Be sure to disconnect the power cord from the electrical outlet before cleaning.
2. When cleaning the remote control or power switch, use a dry cloth only. Never use a damp cloth to clean any electrical component.

CAUTION:

1. Be sure to test any cleaning solution on a small, inconspicuous part of the product to ensure that the color does not fade prior to using the solution on the entire product surface.
2. Do not use benzene, thinner or any other solvents on your product.

Cleaning Code Standard for SofHyde or Cloth: W

To maintain your Human Touch product in optimum condition, dust it frequently and/or vacuum it with a soft brush vacuum extension. If your product becomes dirty, use a water-based upholstery cleaner only. To treat stains, spot clean with an upholstery shampoo or a mild detergent foam.

Caring for Leather Upholstery

Natural leather is a breathing, porous material similar to human skin, and is susceptible to staining due to absorbing dirt, sweat, moisture, oil and grease (e.g., hair products and skin lotions). Do not allow these elements to come into direct contact with the upholstery. To help prevent normal leather cracking and drying, and help prevent staining, apply a high-quality leather cleaner and conditioner at least every three months; this will revitalize and reseal the leather surfaces. Follow the product label instructions carefully; Human Touch is not responsible for third-party products.

Maintenance and Repair:

1. The mechanics of this product are specially designed and constructed to be maintenance free. No periodic lubrication or servicing is required.
2. Your chair should only be serviced by a Human Touch-authorized service representative.

Use and Storage Environment:

1. Do not place the chair in direct or reflected sunlight, as ultraviolet rays will quickly fade the upholstery color and cause SofHyde upholstery to rapidly deteriorate.
2. Operate your chair in a room temperature between 41 and 104 degrees Fahrenheit (5 to 40 degrees Celsius) with humidity levels of 10% to 70% (non-condensing) to avoid damage.
3. To prevent damage to the upholstery, before sitting in your chair make sure there are no sharp objects in your pockets and no metal buttons or zippers that can come in contact with the chair.
4. Do not place the chair where excessive dust and pet hair can migrate into the chair's electrical and mechanical components; this can cause malfunction over time.
5. When not in use for a long period of time, we recommend that the chair be covered, the power cord be coiled, and that the unit be placed in an environment free of dust and moisture.
6. Store your chair in a room temperature between 5 and 122 degrees Fahrenheit (-15 to 50 degrees Celsius) with humidity levels of 10% to 70% (non-condensing) to avoid damage; product stored in cold temperatures may require 48 hours at room temperature to function properly.
7. Do not store near open heat or flame.

Having Trouble?

Should your Perfect Chair exhibit any abnormal recline behavior, please do the following to fully reset the chair; this simple reset sequence will resolve many issues:

1. Unplug the chair from the power source.
2. Wait 30 seconds.
3. Plug the chair back into the power source.

If your chair has no power:

1. Check the power cord - Make sure the power cord is not damaged.
2. Check the wall outlet - Plug a known working device into the outlet to ensure the outlet is working.

If the issue remains, please do the following before contacting our customer experience team (this will help us help you much more quickly):

1. Locate the serial number on label on the back of your chair and write it down.
2. Locate your proof of purchase, as we will need it to process any warranty claim.
3. Now you're ready to contact us!

Contact our Customer Experience team at 800-355-2762, Monday - Thursday 7 AM to 4:30 PM PST, Friday 7 AM to 3:30 PM or csadmin@humantouch.com.

Specifications

*Specifications are subject to change without prior notice.