APC USB Wi-Fi Device Quick Start Guide

AP9834

Step 1

The APC USB Wi-Fi Device is a small, black adapter with the Schneider Electric logo.

? NOTE: A supported Network Management Card 3 (AP9641/AP9643) with valid TCP/IP settings running firmware version 1.4 or higher is required to use and configure the APC USB Wi-Fi Device.

Step 2

Illustration shows the APC USB Wi-Fi Device being inserted into a USB port on a Network Management Card.

Insert the APC USB Wi-Fi Device into an available USB port.

Step 3

? Enable and configure Wi-Fi via the NMC Web UI (Configuration > Network > Wi-Fi navigation path), or Command Line Interface (wifi command).

For more information, consult the NMC 3 User Guide and CLI Guide on the APC website: apc.com/upsnmc

Step 4

Diagram shows the rear panel of a Network Management Card with ports labeled 'USB', 'Uni-Fi I/O', 'Console', and 'Network'. The APC USB Wi-Fi Device is shown plugged into the 'USB' port (labeled '1'). A close-up inset shows the USB ports labeled '1' and '2'.

? NOTE: The APC USB Wi-Fi Device's LED will flash green when Wi-Fi has successfully been configured and connected to the Wi-Fi network.

Step 5

? For more information and troubleshooting, refer to the NMC 3 User Guide on the APC website:

apc.com/us/en/download/document/SPD_CCON-AYCEFJ_EN

	APC UPS Network Management Card 3 (AP9640, AP9641) Installation Manual This document provides detailed installation instructions, configuration steps, and safety information for the APC UPS Network Management Card 3, models AP9640 and AP9641. It covers network setup, access methods, and compatibility.
	Smart-UPS Firmware Upgrade Guide Using the Network Management Card A user guide for upgrading the firmware of APC Smart-UPS models using the Network Management Card. It provides step-by-step instructions and important warnings.
	APC Network Management Cards EU Declaration of Conformity Official EU Declaration of Conformity for APC Network Management Cards (AP9640, AP9641, AP9649) by Schneider Electric, confirming compliance with relevant European directives and standards.
	APC UPS Network Management Card 3 AP9640 Product Datasheet Product datasheet for the APC UPS Network Management Card 3 (AP9640) by Schneider Electric, detailing specifications, environmental conditions, certifications, and packing information.
	APC Smart-UPS On-Line 5kVA Tower 230V SRT5KXLI Specifications Detailed specifications for the APC Smart-UPS On-Line, 5kVA, Tower, 230V, featuring 6x C13+4x C19 IEC outlets, Network Card+SmartSlot, Extended runtime, and W/O rail kit. Includes technical data on input/output voltage, power ratings, battery type, physical dimensions, environmental conditions, and certifications.
	APC SMV/SMVS UPS Battery Cartridge Replacement Quick Installation Guide Step-by-step guide for safely replacing the battery cartridge in APC SMV and SMVS series UPS units (750VA to 3000VA). Includes important safety precautions and instructions from APC by Schneider Electric.
	Schneider Electric REACH Compliance Statement for APC SurgeArrest Essential PL5B-DE Official REACH compliance declaration from Schneider Electric for the APC SurgeArrest Essential PL5B-DE, detailing SVHC content and regulatory adherence as per EC 1907/2006.
	Assigning IP Address to APC Network Management Card Without Software A technical guide detailing how to assign an IP address to an APC Network Management Card (NMC) using command-line tools like ARP and Ping, bypassing the need for proprietary APC software. This guide covers APC SmartUPS models and provides step-by-step instructions for network configuration.