Anker MagGo Power Bank (6.6K)

Getting Started

Place your phone on the charging surface of the power bank. Press the power button once (x1) to turn the charger ON. Press and hold the power button for 2 seconds (2s) to turn it OFF.

Important Safety Instructions

When using this product, basic precautions should always be followed:

• This wireless charger is not compatible with non-Magsafe phone cases, such as Otterbox Defender cases.
• Do not use an adapter with an output of 5V/1A (5W) or less.
• High temperatures will reduce charging speed and restrict power. It is recommended to charge your device in environments with temperatures below 25°C / 77°F.
• Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or personal injury.
• Operating temperature should be between 0°C to 35°C / 32°F to 95°F.
• Do not disassemble this product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or personal injury.
• CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
• To reduce the risk of injury, close supervision is necessary when the product is used near children.
• Do not expose the power bank to rain or snow.
• Do not use the power bank if it is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
• Do not expose a power pack to fire or excessive temperature. Exposure to fire or temperature above 100°C may cause explosion.
• Switch off the power bank when not in use.
• CAUTION: Risk of Fire and Burns. Do Not Open, Crush or Incinerate. Follow Manufacturer's Instructions.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help.

Radiation Exposure Statement: This equipment complies with FCC Radiation exposure limits set forth for an uncontrolled environment. This equipment can be used in portable exposure condition.

Importer Information (for FCC matters): Fantasia Trading LLC, 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764, Telephone: +1 800 988 7973

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure Statement: This equipment complies with IC Radiation exposure limits set forth for an uncontrolled environment. This equipment can be used in portable exposure condition.

Manufacturer: Anker Innovations Limited, Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

Declaration of Conformity

This product complies with the radio interference requirements of the European Community.

Anker Innovations Limited declares that this product is in compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at: https://www.anker.com.

This symbol ♻️ indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

Technical Specifications:

• Frequency band(s) in which the radio equipment operates: 111-360 KHz
• Maximum radio-frequency power transmitted: -12.53 dBuA/m@10m