Product Overview
The Resideo V8205 and VR8205 series are direct ignition combination gas controls designed for gas-fired appliances with capacities up to 200 cfh on natural gas. These controls integrate essential safety shutoff, manual valve operation, automatic operators, and pilot adjustment features. They are factory-set for natural or LP gas and can be converted between gas types using specific conversion kits for models with standard or slow-opening regulators.
Key Features & Applications
- Suitable for natural and manufactured gas or LP gas appliances.
- Available with standard, slow-opening, or step-opening regulators.
- Straight-through body pattern with 1/2 in. inlet and outlet.
- Optional angle and straight adapters available for various pipe sizes (3/8, 1/2, 3/4 in.).
- Approved by American Gas Association, Canadian Gas Association, and Australian Gas Association.
Important Safety Information
WARNING: Installation and service must be performed by a qualified technician. Failure to follow instructions can result in property damage, severe injury, or death. Always disconnect power before wiring and turn off the gas supply before installation. Perform gas leak tests after completion.
CAUTION: Never apply a jumper across or short the valve coil terminals, as this can damage the thermostat's heat anticipator or the ignition module.
Installation Guidelines
Ensure proper installation by following these steps:
- Read all instructions carefully before beginning.
- Check product ratings against application requirements.
- Install in a well-ventilated area, protected from moisture, dust, and excessive heat.
- Use appropriate pipe compound (not Teflon tape) and tighten connections securely.
- Follow specific instructions for installing adapters, flanges, and bushings.
- Ensure correct pipe thread length to avoid valve distortion.
Wiring and Startup
Wiring connections should comply with applicable electrical codes and appliance manufacturer instructions. After installation, perform a gas leak test and check the system's operation, including burner input and safety shutdown performance.
Troubleshooting
Refer to the guide for common issues such as the main burner not coming on, and follow the recommended checks and solutions.
Service and Maintenance
The gas control contains no replaceable parts and should not be disassembled. If the control is damaged or has been flooded with water, it must be replaced by a qualified service technician.
Homeowner Information
Instructions for homeowners on safe operation, including lighting procedures and what to do in case of a gas smell, are provided to ensure safety.
