Victa Robot Mower Quick Start Guide

Important Safety Information

Warning! Read the directions for use before operating the appliance.

Step 1: Prepare the Lawn Area

Ensure the lawn area is clear before operating the robot mower.

Step 2: Positioning the Docking Station

A: Place the docking station in a suitable location.

B: Ensure adequate space around the docking station (refer to diagrams for specific measurements).

C: Position the docking station with sufficient clearance.

D: Connect the boundary wire to the start and end points of the docking station. Allow for extra wire for adjustment.

E: Insert the boundary wire into the docking station.

F: Secure the boundary wire with the provided stakes.

G: Route the boundary wire around the lawn area.

H: Connect the boundary wire to the docking station and plug in the power adapter.

Step 3: Cutting Height Adjustment

Adjust the cutting height of the mower as needed. The recommended cutting height is between 10-15 mm. Ensure the mower will cross the boundary wire (less than 5 mm) and will not cross obstacles like trees (more than 10 cm).

Step 4: Main Switch Location

Locate the main switch for turning the mower ON/OFF.

Step 5: Programming

A: Access the programming menu on the mower's display.

B: Enter the initial PIN code (4 digits).

C: Set the current date and time.

D: Set the desired working time for the mower.

E: The mower will indicate when it is ready to start.

F: Close the cover after programming.

Diagrams:

• Lawn Layout: The diagrams illustrate optimal lawn layout for the robot mower, including placement of docking station (S1, S2), boundary wire routing, and clearances (e.g., > 10m, > 0.5m, > 2m).
• Slope Considerations: The mower can handle slopes up to 40%.
• Boundary Wire Crossing: Diagrams show how the mower interacts with the boundary wire, indicating when it will cross (less than 5 mm) and when it will not cross (more than 10 cm).
• Obstacle Clearance: Ensure sufficient clearance from obstacles like trees (more than 40 cm).
• Wire Placement: Specific measurements for boundary wire placement are provided (e.g., 80 cm, 40 cm).
• Wire Crossing Rule: A crucial rule is illustrated: "Never cross the wires."

Additional Information

For more information, visit VICTA.COM.AU.

Document Reference: 80095661

Version: QUICK START GUIDE, VICTA ROBOT MOWER RM100 27/05/20