Arcade1Up TRON Owner's Manual

Model: TRON

Ages: 14+

Important Safety Instructions

WARNING: TO ENJOY A SAFE GAMING ENVIRONMENT

Please use the wall anchor kit that is included with the product.

Make sure to locate your Arcade1UP on a flat surface.

WARNING: Arcade1UP assumes no liability for improper installation or excessive loads placed on screws or bracket.

This wall anchor is not a substitute for proper adult supervision.

WARNING: Serious or fatal crushing injuries can occur from furniture tip-over. To help prevent tip-over:

Set up Arcade1UP on a level floor.
Never allow children to climb or hang on product.
Always set up an anti-tip device!

Use of tip-over restraints may only reduce, but not eliminate, the risk of tip-over.

EPILEPSY WARNING

A very small percentage of individuals may experience epileptic seizures or blackouts when exposed to certain light patterns or flashing lights. Exposure to certain patterns or backgrounds on a television screen or when playing video games may trigger epileptic seizures or blackouts in these individuals. To reduce the risk of such a seizure incident, it is recommended to take a 10-15 minute break at each hour of playing.

READ BEFORE USING THE Arcade1UP SAFETY PRECAUTIONS

Please read and comprehend all warnings stated in this manual.
Do not get arcade wet when cleaning.
Parents and guardians: Please read entire manual before allowing gamer to play.
The AC/DC adapter and apparatus shall not be exposed to dripping or splashing and that no object filled with liquids, such as vases, shall be placed on apparatus.
The AC/DC adapter is used as disconnect device. The AC/DC adapter of apparatus should not be obstructed OR should be easily accessed during intended use. To be completely disconnect the power input, the AC/DC adapter of apparatus shall be disconnected from the mains.
If appliance is provided with protective earth terminal, it should be connected to main outlet with a protective earth connection.
Minimum distances 10 cm / 3.94 inches around the apparatus for sufficient ventilation.
The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.
No naked flame sources such as lighted candles should be placed on the apparatus.
The apparatus should only be used in moderate climates.

FCC/ISED STATEMENT

This device complies with part 15 of the FCC rules / Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC/ISED rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.

Troubleshooting

Problem	Possible Cause	Solution
Game will not turn on.	-Make sure power cord is plugged into the wall outlet and there is power to that outlet. (Plug other electrical equipment into the power outlet to make sure the outlet normally works.) -Make sure all Wires/Plugs are properly connected and all the way set in as directed in assembly instructions. -Slide ON/OFF Switch located on control deck to the ON position. -Slide upload switch on back of monitor to the ON position.	-Wires/Plugs were hooked up incorrectly. -Power cord is not plugged into wall outlet. -Wires/Plugs are hooked up incorrectly. -ON/OFF Switch is in the OFF position. -Upload switch on back of monitor is in the OFF position.
Game will turn ON, but there is no sound.	-Make sure all Wires/Plugs are properly connected and all the way set in as directed in assembly instructions. -Slide Volume Switch located on control deck to the right. NOTE: Push volume slide switch right to increase volume, left to lower volume.	-Wires/Plugs were hooked up incorrectly. -Volume Switch is in the OFF position.
You hear sound but there is no picture.	-Make sure all Wires/Plugs are properly connected and all the way set in as directed in assembly instructions.	-Wires/Plugs were hooked up incorrectly.
One of the buttons on the control deck is stuck in the down position.	-Debris may have gotten between the button and the button housing.	-Take something thin (like a business card) and place it between the button and the button housing and slide it back and forth to loosen the debris.
You are not able to scroll through the games on the game selection menu.	-Look at the game control section in the instruction manual to make sure you are using the correct joystick or pressing the correct buttons to scroll through the game selection menu.	-You may be using the wrong joystick or pressing the incorrect buttons to scroll through the games.
You are able to scroll through the games on the game selection menu, but you can’t enter a game to begin playing.	-Look at the game control section in the instruction manual to make sure you are pressing the correct button to enter the game.	-You may be pressing the wrong button to enter the game.
You have entered the game, but you can’t get the game to start.	-Look at the game control section in the instruction manual to make sure you are pressing the correct button to start the game.	-You may be pressing the wrong button to start the game.
You have entered the game, but you can’t exit the game to get back to game selection menu.	-Look at the game control section in the instruction manual to make sure you are pressing the correct button to exit the game. -Make sure you are holding the exit button down for 5 seconds to exit the game.	-You may be pressing the wrong button to exit the game. -You may not be holding down the exit button long enough.
The control functions that are printed on the control deck do not match the gameplay on the screen for the game you are playing.	-Look at the game control section in the instruction manual to make sure you are pressing the correct game control buttons for that game. -Look at the game control loading screen on the monitor to make sure you are pressing the correct control buttons. (NOTE: The game controls that are printed on the control deck are only for the feature cabinet game. The other games in the cabinet will utilize the same buttons but react differently.)	-You may be pressing the wrong game control buttons for the game you are playing.
The game will not let me select 2 or 3 players for a chosen game.	-Refer to the game control section in the instruction manual to see how many players are able to play that game.	-The game may only be a 1 or 2 player game.
The game screen looks pixelated or there are lines running through the image.	-Wires/Plugs were hooked up incorrectly.	-Wires/Plugs were hooked up incorrectly.
The game screen is frozen.	-The game encountered a problem when processing the data. -You may need to RESET the game. Turn the ON/OFF switch to the OFF position. Unplug the game from the wall outlet and wait 60 seconds to RESET the game. Plug the game back in and turn the ON/OFF switch back to ON.	-You may need to RESET the game. Turn the ON/OFF switch to the OFF position. Unplug the game from the wall outlet and wait 60 seconds to RESET the game. Plug the game back in and turn the ON/OFF switch back to ON.
Marquee / Light Up Deck Bar / Light Up N1-Panel / Black Light M-Panel will not light up.	-Marquee / Deck Bar / N1-Panel / Black Light M-Panel power cord is not plugged in at the back of the monitor. -Marquee / Deck Bar / N1-Panel / Black Light M-Panel power cord is plugged into the wrong input.	-Make sure all Wires/Plugs are properly connected and all the way set in as directed in assembly instructions.

Collect Them All

Colors, style and decoration may vary.

Featured Games:

STREET FIGHTER™ II BIG BLUE ARCADE1UP
TURTLES IN TIME ARCADE1UP
X-MEN ARCADE1UP
KILLER INSTINCT ARCADE1UP
TRON ARCADE1UP
THE SIMPSONS ARCADE1UP

Visit Arcade1up.com TO SIGN UP FOR OUR MAILING LIST AND SEE A COMPLETE LIST OF GAMES.

TM & © 20th Television

Game Settings

To adjust settings:

Move joystick to scroll through game list.
Move joystick to left then press the Trigger / Player 1 / Player 2 to enter Game Settings.
Move joystick to adjust settings.
Select “DEFAULT SETTINGS” and press the Trigger / Player 1 / Player 2, then choose “YES” and press the Trigger / Player 1 / Player 2 to return the game to its original state.

Game Controls

FOLLOW GAME CONTROLS BELOW FOR EACH GAME

General Controls:

HOLD PLAYER 1 (5 SECONDS) TO RETURN TO MENU
HOLD PLAYER 2 (5 SECONDS) TO RESET GAME
MOVE JOYSTICK TO SCROLL THROUGH GAME LIST
PRESS TRIGGER / PLAYER 1 / PLAYER 2 TO CHOOSE GAME

TRON Specific Controls:

Disc Game:
• ROTATE KNOB TO AIM TRON’S DISC
• PULL TRIGGER TO FIRE DISC OR INCREASE LIGHTCYCLE SPEED
Light Cycles:
• CONTROL GRIP: MOVES TRON ON RINGS. CAUTION: TRON CAN FALL OFF RINGS.
• TO FIRE: SQUEEZE TRIGGER. PRESS BUTTON ON BACK OF CONTROL GRIP TO DEFLECT SARK’S DISCS.

Installation

This game is designed for indoor and personal use only. It must not be installed outdoors.

The following conditions must be avoided:

Direct exposure to sunlight, high humidity, direct water contact, dust, high heat, or extreme cold.
Vibration. The game must be installed on a level surface.

Do not install in an area such that the game would present an obstacle in case of an emergency (i.e., near fire equipment or emergency exits).

Specifications

POWER SUPPLY: AC/DC Adapter
INPUT POWER: AC 100-240V~50/60Hz 2A Max
OUTPUT POWER: DC12V --- 4A
MONITOR: 17” LCD
CABINET ASSEMBLED DIMENSIONS: 49.7” x 18.75” x 22.25” (126cm x 47.62cm x 56.50cm)

Assistance or Service

Before contacting Arcade1Up for assistance or service, please check the "Troubleshooting" section in the User Manual.

If you still have questions regarding your Arcade1Up product or require technical support, contact Arcade1Up Customer Service at www.Arcade1Up.com and click on "Support".

Servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

General Warnings

WARNING: Arcade1UP assumes no liability for improper installation or excessive loads placed on screws or bracket.

This wall anchor is not a substitute for proper adult supervision.

This product is intended for use only with the adapter provided:

Manufacturer: Blue Iron Holdings Ltd.

Model: BI65-120400-E2

The AC/DC adapter is used as disconnect device.
The AC/DC adapter of apparatus should not be obstructed OR should be easily accessed during intended use.
To completely disconnect the power input, the AC/DC adapter of apparatus shall be disconnected from the mains.

ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.

The equipment shall be used at working ambient temperature 32° - 95°F (0° - 35°C).

TIP OVER HAZARD - This apparatus should be secured in place by using the provided mounting means. Free standing is capable of resulting in instability causing possible injury. Refer to the installation instruction for detail.

Additional Safety Information

WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.

Electrical Shock Hazard. Disconnect power before removing cover. Should only be done by a qualified technician.

FCC RF RADIATION EXPOSURE STATEMENT:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.

ISED RF RADIATION EXPOSURE STATEMENT:

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.

	Arcade1Up The Simpsons Owners Manual: Safety, Setup, and Troubleshooting Comprehensive owners manual for the Arcade1Up The Simpsons arcade machine. Includes essential safety precautions, setup guidelines, troubleshooting tips, game controls, and technical specifications for an optimal gaming experience.
	Arcade1Up Terminator 2 Owners Manual: Setup, Safety, and Troubleshooting Guide Official owner's manual for the Arcade1Up Terminator 2 arcade machine (Model TER-A-10159). Provides essential safety precautions, setup guidance, troubleshooting steps, game settings, control explanations, and technical specifications.
	Arcade1Up Class of 81 Owner's Manual - MSP-A-10171 Comprehensive owner's manual for the Arcade1Up Class of 81 (MSP-A-10171) featuring safety instructions, troubleshooting, game settings, and control layouts for classic arcade games.
	Arcade1Up Ridge Racer Owners Manual This comprehensive owners manual provides essential information for the Arcade1Up Ridge Racer home arcade machine. It covers important safety precautions, setup guidelines, game controls, troubleshooting tips, and technical specifications to ensure a safe and enjoyable gaming experience.
	Arcade1Up Marvel vs. Capcom Owner's Manual Comprehensive owner's manual for the Arcade1Up Marvel vs. Capcom arcade machine, providing setup, operation, troubleshooting, and safety guidelines in English, French, and Spanish.
	Street Fighter II Big Blue Arcade1Up Owners Manual Owners manual for the Arcade1Up Street Fighter II Big Blue cabinet, including setup, game controls, settings, troubleshooting, and safety information.
	Arcade1Up Killer Instinct Owners Manual Official owners manual for the Arcade1Up Killer Instinct arcade machine (model KIL-A-01252). Provides essential safety information, setup guides, troubleshooting tips, game control explanations, and technical specifications for optimal use.
	Arcade1Up Pong Owners Manual: Setup, Troubleshooting, and Game Controls Comprehensive owners manual for the Arcade1Up Pong arcade game table, covering setup, safety precautions, troubleshooting common issues, game controls, and specifications. Learn how to operate and maintain your Arcade1Up Pong unit.