DREO Tower Fan Nomad TF414 User Manual

01 IMPORTANT SAFETY INSTRUCTIONS

⚠️ READ ALL CAUTIONARY MARKINGS ON THE APPLIANCE AND SAFETY INSTRUCTIONS IN THE USER MANUAL BEFORE USE.

[Blocked Airflow] Do not cover the air inlet and outlet while in operation.

[Flammable] Do not use the fan near flammables and combustibles.

General Safety

1. Children shall not play with the appliance. Cleaning and maintenance shall not be performed by children without supervision.
2. Use the appliance as described in the user manual only. Any other use not recommended in the user manual may cause fire, electrical shock, or personal injury.
3. This appliance can be used by children aged above 8 years and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of this appliance in a safe way and understand the hazards involved.

Operation Safety

1. Place the appliance on a flat, dry surface before use.
2. Do not immerse in water and any other liquids.
3. Do not use the appliance until the base is installed.
4. Do not insert your fingers, pencil, and any other objects into the grilles while in operation.
5. Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.

Electricity Safety

1. Make sure that the voltage of your electricity supply is the same as that indicated on the appliance.
2. Always unplug before cleaning or leaving the appliance unused for a long period of time. Keep your hands dry when plugging/unplugging.
3. Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
4. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
5. WARNING: To reduce the risk of fire or electric shock, do not use this Fan with any solid-state speed control device.
6. WARNING: To reduce the risk of fire, electric shock or injury to persons, do not use replacement parts that have not been recommended by the manufacturer (e.g. parts made at home using a 3D printer).
7. WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, its services agent or similarly qualified persons in order to avoid a hazard.

FOR HOUSEHOLD USE ONLY

READ AND SAVE THESE INSTRUCTIONS

02 ASSEMBLING YOUR TOWER FAN

Assembly Instructions

When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.

1. [Diagram: Cord run through base halves]

   Run the cord through the center hole of the two base halves.

2. [Diagram: Intersecting base halves]

   Intersect the two base halves diagonally. Match the arched cutout with the arched support on the base. Then, hook them together.

3. [Diagram: Pressing base halves together]

   Press down on the edge until you hear a click to securely snap the two base halves together.

4. [Diagram: Threading cord to fan bottom]

   Thread the cord through the center hole and attach the base to the fan bottom.

5. [Diagram: Aligning arrows on base and fan bottom]

   Make sure the arrows on both the base and fan bottom are aligned.

6. [Diagram: Turning base to lock]

   Turn the base clockwise until it clicks into place.

7. [Diagram: Cord routed through keepers, fan upright]

   Thread the cord through all REAR cord keepers, then set the fan upright.

CAUTION

• Do not operate the tower fan if the base has not been installed.
• Make sure to thread the cord through all rear cord keepers.

03 KNOWING YOUR TOWER FAN

Control Panel

• ? Power Button

  Turn power on/off

• ☰ Mode Button

  Switch between Normal/Natural/Sleep Mode

  Long press for 3 seconds to mute/unmute

• ⏰ Timer Button

  Select to set a timer (0-8h)

• ? Oscillation Button

  Adjust airflow direction

• ? Fan Speed Button

  Adjust airflow volume (1-8 levels)

LED Display

The LED display shows the current operating status. Icons include:

• Fan Speed/Timer Hour (e.g., '8')
• ?️ Normal Mode
• ? Natural Mode
• ? Oscillation
• ? Mute
• ?️ Auto Mode
• ? Sleep Mode
• ℎ Hour Indicator
• ⏰ Timer

04 USING YOUR TOWER FAN

Working Modes

• ?️ Normal Mode

  Fan runs at the constant speed.

• ? Natural Mode

  Fan speed goes up and down intermittently to replicate the natural breeze.

• ?️ Auto Mode

  Fan automatically increases speed when room temp is higher and decreases speed when temp is lower.

• ? Sleep Mode (Mute On)

  Balance comfort and noise by automatically decreasing fan speed as you fall sleep.

  • If the fan speed is 3 or higher, it will decrease two times, one speed every 30 minutes, then it will remain constant.
  • If the fan speed is 3 or below it will remain constant.

Additional Features

• ? Mute

  Long press the ☰ or press ? on the remote control to turn on/off the button sounds.

• ⏰ Timer

  When the fan is ON/OFF, touch the timer button repeatedly to set a timer (1-8h). When the timer ends, the fan will stop/start running automatically. To cancel, set the time to 0 hour.

  Note: Display will return to fan speed after 3 seconds.

Memory

? If the fan is turned OFF and connected to power, it will operate under the previous settings (except the timer setting) when it is turned ON again.

Display Auto Off

• Display turns off after 1 minute (after 5 seconds in sleep mode).
• Wake up the display with any button.

Getting the Most out of Your Tower Fan

1. Remove any tall obstacles that might block the airflow from the fan.
2. Combine with your AC unit to get cooler air throughout the room.
3. Position the tower fan closer to you to get more direct airflow.
4. Place a bucket of ice in front of the fan for an extra cooling boost.

05 CLEANING AND MAINTENANCE

• [Diagram: Wiping outer surface]

  Outer Surface

  Gently wipe off the dust with a soft, dry cloth.

• [Diagram: Vacuuming grilles/blades]

  Grilles & Blades

  Remove the dust using a vacuum or air duster.

• Base

  The base can be disassembled in the reverse order of assembly.

⚠️ CAUTION

1. Always unplug the fan before any cleaning or maintenance.
2. Do not immerse in water or get water inside the motor housing.
3. Do not use any chemical agents when cleaning the fan.
4. Store in a cool, dry place and cover it to protect from dust.

Rear Grille

WARNING: Turn off the appliance and unplug before any cleaning and maintenance.

1. [Diagram: Removing rear grille screw]

   Remove the screw on the top of the rear grille with a Philips screwdriver.

2. [Diagram: Lifting rear grille]

   Lift up the grille and pull it out.

3. [Diagram: Cleaning rear grille/blades]

   Clean the dust on blades using a vacuum cleaner or air duster. Rinse the rear grille under running water or with a clean, damp cloth.

4. [Diagram: Reinstalling rear grille]

   Dry up, then install the grille and the screw back in place, making sure the bottom pegs are fully inserted into the slots.

06 TROUBLESHOOTING

My fan won't turn on!

Make sure that the cord is connected to a powered outlet and the mains voltage corresponds with the voltage indicated on the fan.

My fan is shaky and wobbling!

1. Place the fan on a flat, level surface.
2. Incorrect installation might also cause shakiness. Please refer to the assembly instructions in page 3-4. Note that the power cord must be run through all rear keepers.

My fan is making vibration and noise!

1. Place the fan on a flat, level surface.
2. Be sure not to insert anything into the air inlet and outlet.

If your problem is not listed or still persists, please contact our Customer Support (see page 16).

07 DREO CUSTOMER CARE

Default 24-Month Warranty

This appliance is covered by DREO warranty for 24 months from the date of its original purchase.

Extend Your Warranty

Extend your warranty by registering your new appliance on our website https://dreo.com/warranty.

The warranty will not apply in cases of:

1. Accident, misuse, or repairs performed by unauthorized personnel.
2. Any unit that has been tampered with or used for commercial purposes.
3. Normal wear and tear of wearable parts.
4. Use of force, damage caused by external influences.
5. Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or noncompliance with the instructions.
6. Partially or completely dismantled appliances.
7. Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by DREO.

DREO can only provide after-sales service for products that are sold by DREO or DREO authorized retailers and distributors. If you have purchased the appliance from a different place, please contact your seller for return and warranty issues.

Specifications