Dometic S4 Window Installation and Operation

Figure 1: Window Unit Components

Illustrates the Dometic S4 window unit, including the main frame, the inner frame, and the provided mounting hardware such as screws (1, 2, 3, 4).

Figure 2: Dimensional Specifications

Provides critical dimensions for the window and its installation: Height (H), Width (W), and frame depth (B). It also shows different mounting hole patterns (A, B, C, D) with precise measurements, such as 12 mm from edges and a 24 mm diameter hole.

Configuration A and B show dimensions H and B. Configuration B also shows B+4 mm and H+3 mm.

Configuration C shows 12 mm and 12 mm markings. Configuration D shows a Ø 24 mm hole.

Figure 3: Component Attachment and Assembly

Details the process of attaching a specific component (A) and then assembling further parts (B) in sequential steps (1, 2).

Figure 4: Panel Installation

Shows the installation of a panel, labeled 'W'.

Figure 5: Configuration Dimensions

Presents two configurations, A and B, with associated dimensions labeled 'h' and 'W'.

Figure 6: Preparation for Installation

A hand is shown holding the window frame, indicating readiness for placement and installation.

Figure 7: Sealant Application

Illustrates the application of sealant around the mounting area to ensure a watertight seal.

Figure 8: Securing the Frame

Shows the window frame being attached to the vehicle's wall. Screws (1) are used to secure the frame. A torque wrench is indicated, with a specified tightening torque of ≤ 3 Nm (2) to prevent overtightening.

Figure 9: Opening the Window

Demonstrates how to release a latch mechanism (1) to allow the window to be opened (2).

Figure 10: Window Movement

Illustrates the sequence for opening the window further (1) and subsequently closing it (2).

Figure 11: Locking Mechanism

Shows the operation of the window's locking mechanism.

Figure 12: Fully Opened Window

Depicts the window in its fully open position.

Figure 13: Blind Deployment

Illustrates the deployment of the integrated internal blind (1).

Figure 14: Engaging Locks

Shows the final step of engaging the locking mechanisms (1, 2) to secure the window.