Resideo Braukmann MV300 Installation Instructions

E1 Components

Description of the main components of the Braukmann MV300 valve system.

• Magnetic solenoid valve (➀): Controls the flow of water.
• Filter insert (➁): Filters impurities from the water.
• Manual ball valve (➂): Used for shut-off or isolation.

Diagram Description: A detailed illustration shows the valve assembly. Callout ➀ points to the magnetic solenoid valve. Callout ➁ indicates the filter insert. Callout ➂ highlights the manual ball valve.

E2 Installation

Instructions for installing the Braukmann MV300 valve into a piping system.

Operating Conditions:

• Temperature: [temperature above 0°C] and [max 80°C].
• Pressure: [min 0.7 bar] and [max 16 bar].

Diagram Description: This diagram illustrates the installation process. The valve assembly is shown integrated into a pipeline. Two manual ball valves are positioned on either side of the main unit for isolation. The main unit comprises the solenoid valve (➀) and filter insert (➁). The diagram indicates the direction of water flow.

E3 Commissioning

Steps for commissioning and setting up the Braukmann MV300 valve.

1. Electrical Connections:
   • Version A: 230 V, 50 Hz, IP65 rating.
   • Version B: 24 V, 50 Hz, IP65 rating.
   Diagram Description: Shows two electrical connection options, labeled Version A and Version B, with their respective voltage and frequency specifications.
2. Diagram Description: Depicts the valve assembly installed within the pipework.
3. Diagram Description: Illustrates the operation of a manual ball valve (labeled 3) in the system.
4. Diagram Description: A hand is shown manipulating a control element on the valve assembly.
5. Diagram Description: Shows the electrical wiring being connected to the solenoid valve.
6. Diagram Description: The final installed and operational state of the Braukmann MV300 valve system.