GoHawk TJ4-Q/TN4-Q Powersports Amplified Stereo System

1. Contents

• 4 x Speaker
• 1 x Amplifier
• 1 x Wired Control
• 2 x Antenna
• 1 x AUX Cable
• 4 x Mounting Clamp
• 1 x Screw Kit
• 2 x Hex Screw Driver
• 1 x Power Cord
• 1 x Fuse
• 1 x User's Manual

2. Features

• 4" High-Performance Waterproof Speakers
• Support USB & SD Card input
• Built-In Bluetooth 5.0 for Audio Streaming
• 3.5mm AUX Input Jack
• Built-In FM Radio Receiver
• LCD Display
• All-Function Wired Remote
• Advanced Plating Process - Fade and Scratches Resistant

3. Read Before Installation

1. The components and wiring should not be installed on or around any moving parts, keep away from ignition parts, fuel lines, engine or any hot exhaust.
2. Speakers should not be installed where they might inhibit safety features on the vehicle such as lights, horns, brake levers, etc.
3. Always test the speakers/amplifier prior to installation. Connect to the battery and play the music at least 3-minute to ensure the product is fully functional.
4. Cutting rubber insert may be required for certain bar sizes.
5. Splash, water and dust resistance are not permanent conditions and resistance might decrease as a result of normal wear.
6. To avoid battery draining, disconnect the speaker from the battery if the motorcycle/ATV is planned non-operation for more than 15 days.
7. Engine, pipe and wind noise will overpower any speakers once it reaches certain speeds, it is physics and unavoidable.
8. Please connect to a correct power supply (DC 12V).

4. Installation

Amplifier Installation:

This amplifier is not waterproof. It is required to install in a shaded area to avoid rains and direct sunlight.

Wiring:

1. Connect the speakers to ④ ⑤ ⑥ ⑦.
2. Connect the antenna to ① BT (Bluetooth) or ② AT(Radio).
3. Connect the wired control to 3.
4. Plug in the power cord to the 8 DC power input and connect to a 12V battery. (Positive: RED, Negative: Black)

Amplifier Panel Diagram:

The amplifier panel features the following:

• ⑨ LCD Display
• ⑩ Play/Pause, Mode (On/Off)
• ⑪ Volume +/-
• ⑫ Previous / Next
• ⑬ USB Port
• ⑭ Bluetooth Indicator
• ⑮ SD Card Slot
• ⑯ AUX-IN

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Increase the separation between the equipment and receiver.
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.