Ugreen HITUNE X5 WS108 TWS Earphones

Introduction

Welcome to the Ugreen HITUNE X5 WS108 TWS earphones. This manual provides essential information for safe and proper use.

Device Purpose

This device is designed for personal listening of music, speech, or other audio signals.

Precautions

• Avoid exposing the device to moisture to prevent short circuits.
• Do not expose the device to direct sunlight or high temperatures, as this may shorten the lifespan of electronic components, damage the battery, or deform plastic parts.
• Do not use or store the device at extremely low temperatures to avoid damaging the printed circuit board.
• Do not open or attempt to repair the device yourself. Service and repairs should only be performed by qualified specialists at an authorized service center.
• Do not subject the device to impacts or excessive vibration; do not drop it.
• Do not use aggressive chemicals or cleaning agents to clean the device.
• Do not scratch the surface with sharp objects to avoid damaging the casing and appearance of the device.

Battery Recommendations (Li-pol/Li-ion)

• Use only original charging equipment.
• Observe the temperature range. Batteries should be stored charged at temperatures between +15°C and +35°C with normal air humidity. Batteries do not tolerate prolonged use at very high (above 40°C) or very low (below -10°C) ambient temperatures.
• Do not leave the battery in direct sunlight.
• Do not disassemble, incinerate, or use batteries with signs of damage.

Device Diagram

Earphones

Description of Earphone Components:

• 1. Speaker hole
• 2. Indicator light / Microphone 1
• 3. Multifunction button
• 4. Microphone 2
• 5. Eartip
• 6. L/R marking
• 7. Charging contacts

Charging Case

Description of Charging Case Components:

• 1. USB Type-C charging port
• 2. Indicator lights
• 3. Reset button

Technical Specifications

Package Contents

• Earphones
• Eartips
• Charging case
• USB Type-C charging cable
• User manual

Operating Instructions

Initial Setup

Before first use, remove the protective film from both earphones and fully charge the earphones and charging case using a 5V/1A adapter.

Power On/Off

• Remove the earphones from the charging case; they will automatically turn on.
• Place the left and right earphones into the charging case and close the lid; they will automatically turn off.

Bluetooth Connection

• When you take both earphones out of the charging case, they will automatically turn on and pair with each other.
• Enable Bluetooth on your phone or other device, find "UGREEN HiTune X5" in the device list, and tap to connect. Upon successful connection, you will hear the phrase "Bluetooth connected".
• Automatic Reconnection: The earphones will automatically reconnect to a previously paired phone/device if Bluetooth is enabled on that device and the history of connected Bluetooth devices has not been cleared.

Resetting to Factory Settings

If the earphones become unresponsive, do not pair, or do not connect to your device, perform a factory reset.

1. Remove the "UGREEN HiTune X5" information from your device's Bluetooth list.
2. Place the earphones in the charging case, keep the case lid open, and press and hold the reset button on the charging case for 10 seconds until the indicator lights flash, signaling a successful reset.

Important Notes

• If you move beyond the maximum operating range of 10 meters, the earphones will automatically disconnect from your device. The earphones will automatically reconnect if you re-enter the valid range within the next 5 minutes. If you do not re-enter the range within 5 minutes, the earphones will automatically enter sleep mode.
• If the earphones are not connected to any device for 5 minutes, they will automatically enter sleep mode.

Multifunctional Button Operations

Music Playback

• Press the button on the left/right earphone once to pause or resume playback.
• Press the button on the right earphone three times to skip to the next track.
• Press the button on the left earphone three times to skip to the previous track.
• Press the button on the right earphone twice to increase volume.
• Press the button on the left earphone twice to decrease volume.

Audio Mode Switching

Press the button on the left/right earphone four times to switch between Normal mode and Gaming mode.

Calls

• Press the button on the left/right earphone once to answer or end a call.
• Press and hold the button on the left/right earphone for 2 seconds to reject a call.

Voice Assistant

Press and hold the button on the left/right earphone for 2 seconds until you hear a sound prompt to activate the voice assistant.

Earphone Charge Level and Charging

The earphone charge level is displayed in the upper right corner of your phone (if the phone supports this function). To charge the earphones, place them in the charging case. The charging case indicator lights will flash during charging (the 1st indicator signifies the left earphone, the 3rd indicator signifies the right earphone). If the earphone battery is low, a voice prompt "Battery low" will be heard, after which you should place the earphones in the charging case for charging.

Charging Case Charge Level and Charging

Use the included charging cable and a standard 5V/1A adapter to charge the charging case. To check the charging case's charge level, open the charging case; the indicator light will display the charge level. If the charge level is less than 5%, the 1st indicator will blink for 3 seconds. Each indicator represents approximately 33.3% of the battery capacity. When fully charged, all 3 indicator lights on the charging case will be solid white.

Charging Case Indicator Lights

Voice Prompts

Earphone Indicator Lights

Troubleshooting

Warranty Conditions

The manufacturer guarantees the uninterrupted operation of the device throughout the entire warranty period, as well as freedom from defects in materials and workmanship. The warranty period is calculated from the date of purchase and applies only to new products. Warranty service includes free repair or replacement of components that have failed through no fault of the consumer during the warranty period, provided the product is used according to the user manual. Repair or replacement of components is carried out at authorized service centers.

Actual list of service centers available at: https://www.dns-shop.ru/technical-support/

Warranty period: 12 months.

Service life: 24 months.

Rules and Conditions for Installation, Storage, Transportation, and Disposal

• The device does not require any installation or permanent fixation.
• Storage: The device should be stored in its packaging in heated rooms at the manufacturer's and consumer's premises at an air temperature of 5°C to 40°C and relative humidity not exceeding 80%. The premises should not contain aggressive impurities (acid or alkali vapors) that cause corrosion.
• Transportation: The device should be transported in a dry environment.
• Handling: The device requires careful handling; protect it from dust, dirt, impacts, moisture, fire, etc.
• Disposal: After the product's service life, it must not be disposed of with ordinary household waste. Instead, it should be handed over for recycling at a designated collection point for electrical and electronic equipment for subsequent processing and disposal in accordance with federal or local legislation. By ensuring proper disposal of this product, you help conserve natural resources and prevent environmental and human health damage that may occur from improper handling. More detailed information on collection and disposal points for this product can be obtained from local municipal authorities or waste management companies.

Additional Information

Manufacturer: DONGGUAN KOPPO ELECTRONICS CO., LTD. Building 1, No.2 Road 3, Buxinji Industrial Area, Guanjingtou Village, Fenggang Town, Dongguan City, GuangDong Province, P.R.C.

Made in China.

Importer in Russia / Authorized representative: Atlas LLC, 690068, Russia, Primorsky Krai, Vladivostok, Prospect 100-letiya Vladivostoka, Building 155, Block 3, Office 5.

The product complies with the requirements of the Technical Regulation of the Eurasian Economic Union TR EAEU 037/2016 "On Restriction of Hazardous Substances in Electrical and Electronic Equipment".

The device's configuration, as well as its appearance and specifications, are subject to change without prior notice.

EAC Mark

Production date is indicated on the packaging.

Version: V.1