i.safe MOBILE IS-MC930.1 Multi Charger

Introduction

This document contains information and safety regulations that must be observed for the safe operation of the Multi Charger for IS945, IS940, IS930, and IS910 series devices (IS-MC930.1) under the described conditions. Non-observance of this information and instructions can have serious consequences and may violate regulations. Please read the manual and these safety instructions before using the device. In case of any doubt, the German version shall apply.

The current EU-declaration of conformity, certificates, safety instructions, and manuals can be found at www.isafe-mobile.com, or requested from i.safe MOBILE GmbH.

Reservation

The content of this document is presented as it currently exists. i.safe MOBILE GmbH does not provide any explicit or tacit guarantee for the accuracy or completeness of the content of this document, including, but not restricted to, the tacit guarantee of market suitability or fitness for a specific purpose unless applicable laws or court decisions make liability mandatory.

i.safe MOBILE GmbH reserves the right to make changes to this document or to withdraw it any time without prior notice. Technical Data is subject to change without notice. Changes, errors, and misprints may not be used as a basis for any claim for damages. All rights reserved.

i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or indirect damages caused by any improper use of this device.

EU Declaration of Conformity

The EU-declaration of conformity can be found at the end of this manual.

Faults and Damages

If there is any reason to suspect that the safety of the device has been compromised, it must be withdrawn from use immediately. Measures must be taken to prevent any accidental restarting of the device. The safety of the device may be compromised, if, for example:

• Malfunctions occur.
• The housing of the device shows damage.
• The device has been exposed to excessive loads.
• The device has been stored improperly.
• Markings or labels on the device are illegible.

i.safe MOBILE GmbH recommends that a device displaying errors or in which an error is suspected be sent back to i.safe MOBILE GmbH to be checked.

Ex-Relevant Safety Regulations

The i.safe MOBILE IS-MC930.1 may only be used outside potentially explosive areas. The allowed Multi Charger/Tablet combinations for the charging process are listed in the table below.

Allowed Multi Charger/Tablet Combinations

• Devices may only be charged at ambient temperatures between +5°C ... +35°C.
• The device may not be exposed to any aggressive acids or alkalis.
• Only accessories approved by i.safe MOBILE GmbH may be used.

Further Safety Advices

• Use the device under dry indoor conditions only.
• Do not put the device in environments with excessive temperatures.
• Do not use the device near any flammable or explosive substances.
• Do not use the device in environments with much dust or humidity.
• The device may only be used at ambient temperatures between +5°C ... +35°C.
• Do not use the device in areas where regulations or legislatives prohibit the use.
• Do not expose the device or charger to strong magnetic fields, such as are emitted from induction ovens or microwaves.
• Do not attempt to open or repair the device. Improper repair or opening can lead to the destruction of the device, fire, or explosion.
• Only authorized personnel are allowed to repair the device.
• Only use accessories approved by i.safe MOBILE GmbH.
• Please power off the device and disconnect the power cable before cleaning the device.
• Do not use any chemical cleaning agents to clean the device or the charger. Use a damp and anti-static soft cloth for cleaning.

Maintenance / Repair

Please note any legal requirements for periodic inspection. The device itself has no user-serviceable parts. It is recommended to perform inspections according to the safety regulations and advises. If there is a problem with the device, please contact your vendor or consult the service center. If your device is in need of repair, you can either contact the service center or your vendor.

Connecting the Device

Connect the power supply connector of the device (1) with the delivered power supply cable (2). Then connect the power supply cable to the wall socket.

Component Labels:

• 1: Power supply connector
• 2: Power supply cable
• 3: Charging slot
• 4: USB-C cable

Visual Description: The image shows the multi-charger unit with multiple charging slots. Each slot has an integrated USB-C cable. A separate power supply cable connects to the charger and then to a wall socket. Connection examples illustrate how to insert tablets from the IS910, IS930, and IS940/IS945 series into the charging slots.

Charging the Tablet

Insert the Tablet into a free charging slot (3) of the IS-MC930.1. Connect the Tablet with the USB-C cable (4) of the selected IS-MC930.1 charging slot.

Please refer to the table "Allowed Multi Charger/Tablet combinations" on page 5.

Notice

The battery charging status of the i.safe MOBILE Tablet is indicated directly on the device. Please refer to the user manual of your IS945, IS940, IS930, or IS910 series Tablet/non Ex RugGear Tablet.

Troubleshooting

If problems occur, please contact your vendor or i.safe MOBILE GmbH directly.

Recycling

The crossed-out wheeled-bin symbol ♻️ on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union.

Do not dispose of these products as unsorted municipal waste. Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of materials.

More detailed information is available from the product retailer, local waste authorities, national producer responsibility organisations, or your local i.safe MOBILE GmbH representative.

Trademarks

i.safe MOBILE and the i.safe MOBILE logo are registered trademarks of i.safe MOBILE GmbH. All other trademarks and copyrights are the properties of their respective owners.

Contact/Service Centre

For further questions, please contact our service centre:

i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen, Germany
Email: support@isafe-mobile.com
Website: https://support.isafe-mobile.com

EU Declaration of Conformity

According to directive 2014/30/EU, 2014/35/EU, 2011/65/EU and amendment (EU) 2015/863.

Lauda-Koenigshofen, 27.08.2019

Dirk Amann
Managing Director