V-TAC LED Prismatic Fitting
Installation Instructions
Technical Data
| Model | Wattage | Lumens | Color Temp | Beam Angle | Voltage | IP Rating | Lifespan | Warranty |
|---|---|---|---|---|---|---|---|---|
| VT-8-10 | 10W | 900lm | 3000K/4000K/6500K | 120° | AC:220-240V, 50Hz | IP20 | 30,000 Hrs | 5 Years |
| VT-8-20 | 20W | 1800lm | 3000K/4000K/6500K | 120° | AC:220-240V, 50Hz | IP20 | 30,000 Hrs | 5 Years |
| VT-8-40 | 40W | 3600lm | 3000K/4000K/6500K | 120° | AC:220-240V, 50Hz | IP20 | 30,000 Hrs | 5 Years |
| VT-8-50 | 50W | 4500lm | 3000K/4000K/6500K | 120° | AC:220-240V, 50Hz | IP20 | 30,000 Hrs | 5 Years |
| VT-8-60 | 60W | 5400lm | 3000K/4000K/6500K | 120° | AC:220-240V, 50Hz | IP20 | 30,000 Hrs | 5 Years |
Introduction & Warranty
Thank you for selecting and purchasing a V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact your dealer or local vendor from whom you purchased the product. They are trained and ready to serve you at the best.
The warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 hours daily operation. Usage of the product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.
Warnings
- Please ensure power is turned OFF before starting the installation.
- Installation must be performed by a qualified electrician.
- ? The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
- ⚙️ The control gear of this luminaire is not replaceable.
- For Indoor use only.
- Before installation, carefully check the integrity of the product and its accessories.
- When installed, ensure products and flammable materials are at least 0.2m distance from the fitting. Do not install lighting on a zenith or heated wall. Pay attention to separating low voltage and high voltage electrical wiring.
- To ensure the power cord has sufficient length, do not kink cables. Output cables should be laid separately and at a distance from other cables.
- ⚠️ Caution, risk of electric shock.
- ♻️ Disposal: This marking indicates that this product should not be disposed of with other household wastes.
Installation Instructions
- Step 1: Choose the right position, drill two holes, and insert screws. Ensure the distance between the holes is at least 50mm (minus the bracket length).
- Step 2: Align the screw head (or 'shrapnel point') with the drilled holes and install the screws.
- Step 3: Press the lamp body firmly into the mounting buckle to secure it. Slide the lamp body along the mounting buckle to the desired position as needed.
- Step 4: Connect the wiring using insulating tape and waterproof tape for electrical and waterproofing. Turn on the power and test.
